Abstract:The reporting and evaluation of creep tests of concrete is complicated by the fact that creep is significant even for the shortest observable load durations. Compared to the strain after 0.1 s load duration, the strain at 2 hour duration is typically 53% greater. Most experimenters have for decades been unaware of this fact. Consequently, the reported creep curves require correction by a time shift, which ranges from 0 to 2 hours. This further implies a vertical shift of entire creep curve, important for all times up to structure lifetime. To filter out the errors, it is argued that, within an initial period during which the advance of hydration is negligible, which is normally about 1 day, the initial basic creep must follow a power law of the time. Creep test data from the literature are used to prove it. Corrections by time and deformation shifts are determined by minimization of the sum of squared deviations of the power law from the creep test data. For a fixed exponent n and time shift s, the optimization is reduced to linear regressions of two kinds, depending on whether the data are given in terms of either the compliance function or the creep coefficient. For both, the linear regression parameters depend nonlinearly on the chosen values of n and s. To avoid nonlinear optimization, which need not converge to the correct result, a set of many discrete values of n and s within their realistic ranges is selected and the (n,s) combination minimizing the objective function is obtained by a search. Enforcing a power law form of the initial creep curve is found to lead to better data fits. The optimum exponent n for the entire database is around 0.3, applicable to the time period cca (10 s, 1 day). After that, the exponent transits to about 0.1, and prior to that it is about 0.08.

Analysis on Bazant's Solidification Theory for Concrete Creep

Creep Model of High-Performance Concrete at Different Loading Ages

An improved approach for the continuous retardation spectra of concrete creep and applications

Calculation of Concrete Creep Based on the Equivalent Modulus and ANSYS

Simulating Analysis on Temperature Creep Stress of Shapai RCC Arch Dam

Measurement and Modeling of Creep Property of High-Strength Concrete Considering Stress Relaxation Effect

A Modified Creep Index and Its Application to Viscoplastic Modelling of Soft Clays

Comparison of Concrete Creep-Induced Structural Prestress Loss Calculated by Codes from Different Countries

Nonlinear Creep Damage Constitutive Model of Concrete Based on Fractional Calculus Theory

Discussion on constitutive relation of concrete creep and shrinkage by numerical calculation

Theoretical and Experimental Investigation of Loading Effects on Chloride Diffusion in Saturated Concrete

Numerical Simulation of High-Strength Concrete Creep under Cyclic Load

Constitutive model of concrete creep damage considering the deterioration of creep parameters

Calculation of Concrete Creep witll consideration of influence of Reinforcement Bars

Long-term Behavior of Composite Beams with Shrinkage, Creep and Cracking(ⅱ):Theoretical Analysis

Experimental Study of Loading and Unloading Tensile and Compressive Creep of Hydraulic Concrete in Water

Tensile Creep Behavior of Concrete Subject to Constant Restraint at Very Early Ages

A Study on Continuous Retardation Spectrum of Mass Concrete

Extended Microprestress-Solidification Theory (XMPS) for Long-Term Creep and Diffusion Size Effect in Concrete at Variable Environment

Statistical Extraction of Useful Concrete Creep Data from Imperfect Customary Tests

SHORT-TERM THERMAL CREEP MODEL OF CONCRETE BASED ON EXPERIMENTS