Abstract:The reporting and evaluation of creep tests of concrete is complicated by the fact that creep is significant even for the shortest observable load durations. Compared to the strain after 0.1 s load duration, the strain at 2 hour duration is typically 53% greater. Most experimenters have for decades been unaware of this fact. Consequently, the reported creep curves require correction by a time shift, which ranges from 0 to 2 hours. This further implies a vertical shift of entire creep curve, important for all times up to structure lifetime. To filter out the errors, it is argued that, within an initial period during which the advance of hydration is negligible, which is normally about 1 day, the initial basic creep must follow a power law of the time. Creep test data from the literature are used to prove it. Corrections by time and deformation shifts are determined by minimization of the sum of squared deviations of the power law from the creep test data. For a fixed exponent n and time shift s, the optimization is reduced to linear regressions of two kinds, depending on whether the data are given in terms of either the compliance function or the creep coefficient. For both, the linear regression parameters depend nonlinearly on the chosen values of n and s. To avoid nonlinear optimization, which need not converge to the correct result, a set of many discrete values of n and s within their realistic ranges is selected and the (n,s) combination minimizing the objective function is obtained by a search. Enforcing a power law form of the initial creep curve is found to lead to better data fits. The optimum exponent n for the entire database is around 0.3, applicable to the time period cca (10 s, 1 day). After that, the exponent transits to about 0.1, and prior to that it is about 0.08.

Statistical Extraction of Useful Concrete Creep Data from Imperfect Customary Tests

Creep Model of High-Performance Concrete at Different Loading Ages

Comparison of Compressive, Tensile, and Flexural Creep of Early-Age Concretes under Sealed and Drying Conditions

Modeling compressive basic creep of concrete at early age

Nonlinear Creep of Early-Age Cement Mortar Assessed by Minutes-Long Flexural Test

Experimental Study of the Creep Effect on the Mechanical Properties of Concrete

Calculation of Short-Term Creep of Concrete Using Fractional Viscoelastic Model

Methodology of Obtaining Intrinsic Creep Property of Concrete by Flexural Deflection Test

Measurement and Modeling of Creep Property of High-Strength Concrete Considering Stress Relaxation Effect

Creep Effect on Time to Corrosion-Induced Cracking of Concrete Cover

Calculation of Creep Deformation of Stiffness-Degraded RC Beams after Strengthening with Increased Cross-Section

Early-Age Evolution of Strength, Stiffness, and Non-Aging Creep of Concretes: Experimental Characterization and Correlation Analysis

Description of Concrete Creep under Time-Varying Stress Using Parallel Creep Curve

On the Interrupted Creep Test under Low Stress Levels for the Power Law Parameter Extraction

THE INFLUENCE OF THE LEVEL OF LOAD ON THE COEFFICIENT OF THE CREEP OF CONCRETE

An improved approach for the continuous retardation spectra of concrete creep and applications

Nonlinear creep properties and time-to-failure prediction of sandstone under saturated and dry conditions

Tensile Creep Behavior of Concrete Subject to Constant Restraint at Very Early Ages

A comparison of extrapolation techniques for long-term creep strain and creep life prediction based on equations designed to represent creep curve shape

Predicting Creep Strengths and Lifetimes of Creep Resistant Engineering Alloys

Experimental Study of Loading and Unloading Tensile and Compressive Creep of Hydraulic Concrete in Water