Abstract:Yttrium stabilized zirconia (ZrO2)0.92(Y2O3)0.08 (YSZ) is synthesized using the solid method and formed by plaster casting technique to make an electrolyte of a solid oxide fuel cell (SOFC). The densities of the obtained samples increase as the sintering temperature increases. The relative density of the sample sintered at 1550°C is 93%. Gas-tight can be realized as the thickness of the sample is 0.2 mm, so that it can be used as the electrolyte of an SOFC. Cubic fluorite structures appear in the samples sintered above 1300°C. The results of SEM measurement show that as the sintering temperature is raised, the crystal grain size of the sample increases and the porosity decreases. The results obtained by measuring the electrical properties show that, under the same temperature, the grain resistivities of the samples sintered at different temperatures are almost the same, but the crystal boundary resistivities are different. It can be calculated from the experimental results that the conductive activation energy of the crystal boundary for the samples sintered at 1300°C, 1400°C, and 1550°C is 0.66, 0.86 and 0.98 eV, respectively, and that of the grain for the samples sintered at different temperatures is 0.82 eV. Spigot-shaped electrolyte components are made using the above mentioned technique, and a two-cell-series SOFC is set up. Its maximum output is about 0.1 W/cm2 at 930°C.

Preparation of Tubular YSZ Electrolyte and Its Application in Solid Oxide Fuel Cells

YSZ Thin Films Prepared by a Novel Powder Coating Process on Porous NiO-YSZ Cermet

Preparation of YSZ Electrolyte Membrane Tube by Vacuum Casting and Its Application to Solid Oxide Fuel Cells

Study on the Properties of Ysz Electrolyte Made by Plaster Casting Method and the Applications in Solid Oxide Fuel Cells

Preparation of Yttria Stabilized Zirconia Powders with a Glycine-Nitrate Process for Intermediate-Temperature Solid Oxide Fuel Cells

Preparation of electrolyte membranes for micro tubular solid oxide fuel cells

Preparation and application of electrolyte membrane tube

Sintering and Electrical Properties of YSZ Electrolyte Tubes with Thin Wall Prepared by an Improved Slip Casting

The fabrication technique of YSZ electrolyte film

Research on Sintering Process of YSZ Electrolyte

High Performance Anode-Supported Tubular Solid Oxide Fuel Cells Fabricated by a Novel Slurry-Casting Method

Preparation of Bi2O3-YSZ and YSB-YSZ Composite Powders by a Microemulsion Method and Their Performance as Electrolytes in a Solid Oxide Fuel Cell

Fabrication, Microstructure and Properties of A Ysz Electrolyte for Sofcs

Study on Preparation and Properties of YSZ Electrolyte Membrane Tubes with Low Cost

Performance Evaluation of Solid Oxide Fuel Cells with Thin Film Electrolyte Fabricated by Binder‐Assisted Slurry Casting

Preparation of YSZ thin films for intermediate temperature solid oxide fuel cells by dip-coating method

High Performance Solid Oxide Fuel Cells Based on Tri-Layer Yttria-Stabilized Zirconia by Low Temperature Sintering Process

Development of yttria-stabilized zirconia thin films via slurry spin coating for intermediate-to-low temperature solid oxide fuel cells

Performance Evaluation of Thin Membranes Solid Oxide Fuel Cell Prepared by Pressure-Assisted Slurry-Casting

Solid Oxide Fuel Cells with Dense Yttria-Stabilized Zirconia Electrolyte Membranes Fabricated by a Dry Pressing Process

Fabrication and Characterizations of Ysz Electrolyte Films for Sofc