Abstract:This work studied the projected vertical flame height of buoyant turbulent horizontally-oriented rectangular-source jet fires. Nine burners with three exit areas and various aspect ratios (1–1 to 71–1) which including axisymmetric, rectangular and line-type sources were used in the experiments. During the experiments, the shorter side of the burner was perpendicular to the ground. The projected vertical flame height Hf, refers to distance between the burner and the flame tip in the vertical direction, was measured and analyzed. Models for the Hf reported previously were mainly for circular burners which were not applicable for rectangular burners. For a given burner exit area and heat release rate, Hf firstly increases with the increasing of burner aspect ratio n from 1–1 to 7–1, and then decreases with the increasing of n from 7–1 to 71–1. For a given n, the projected vertical flame height Hf firstly increases (due to increase of fuel supply) and then decreases (due to increase of horizontal momentum) with the increasing of heat release rate (HRR), showing an inherent transition behavior. The critical dimensionless HRR Q˙critical* (by employing the burner perimeter P as characteristic length scale) for this transition behavior decreases with the increased burner aspect ratio. A function was proposed for Q˙critical* of various burner aspect ratios. The normalized flame height, Hf/P, is well represented with the dimensionless heat release rate Q˙* when it is smaller than the critical value (Q˙critical*). Meanwhile, for data with dimensionless HRR larger than the critical value, Hf/Hf,critical is well represented with Q˙/Q˙critical, where Hf,critical is the critical (maximum) projected vertical flame height at Q˙critical of transitional state. The present study provides new observations and fundamentals for the transitional behavior of vertical flame height of horizontally-oriented rectangular-source jet fires.

THEORETICAL MODEL AND EXPERIMENTAL STUDY OF BURNER NOZZLE JET RIGIDITY IN FURNACE

Influence of Structural Parameters of Double-Channel SA/OFA Burner on Jet Rigidity

Investigation on the Effect of Primary Air Momentum on Rigidity in Combined Jets

EXPERIMENTAL STUDY OF JET CHARACTERISTICS OF HBC-SSA BURNER IN TANGENTIALLY FIRED FLOW FIELD

Experimental study, dimensional analysis and an integral model for horizontal buoyant turbulent jet fires under opposing wind

Numerical experiment on complex characteristics of perimeter air deflectable deposited burner

STUDY ON SEPARATION AND RESISTANCE PROPERTIES OF VENTURI RICH/ LEAN PULVERIZED COAL BURNERS

A Mixture Fraction-Based Model and Axial Thermal Positions for Buoyancy/Momentum-Controlled Jet Diffusion Flames

Experimental Study on the Flame Trajectory Evolution of Horizontal Jet Fires under Reduced Pressures

Investigation of NOx emission under different burner structures with the optimized combustion model

Experimental Investigation on Flow Structures and Mixing Mechanisms of a Gas–solid Burner Jet

Transitional Behavior of Vertical Flame Height of Horizontally-Oriented Rectangular-Source Jet Fires

EXPERIMENTS AND NUMERICAL SIMULATION ON FLOW FIELD OF HEXAGONAL ARRANGED BOILER WITH A HIGH LENGTH-WIDTH RATIO DURING ABSENT-ANGLE RUNNING

Experimental Study And Numerical Simulation On A Novel Structure Of Dual Register Whirl Burner

EXPERIMENTAL AND NUMERICAL STUDY ON THE IMPROVEMENT OF THE VANES OF THE HORIZONTAL BIAS BURNER

Experimental Study of Flow Field at the Outlet of Dual-Channel Burner

Flame Morphology of Horizontal Jets under Sub-Atmospheric Pressures: Experiment, Dimensional Analysis and an Integral Model

EXPERAMENTAL STUDY ON FLOW FIELD BEHAVIOR CONCERNING THE CROSSED JET FLOWS OF MICRO-SWIRLING PRIMARY AIR AS WELL AS UPPER AND LOWER SECONDARY AIR

Cold Model Experimental Study on the Concentrated Dual Register Swirl Burner

Experimental investigation on flame morphology and wall-attached flame temperature of jet flame under the coupled effect of nozzle angle and nozzle-wall spacing

Theoretical analysis of combustion process in pulverized coal fired burner using jets with velocity difference (I)