Abstract:Based on theory analyses and simulating experimental verifications in a 6 kV power network,the characteristics of transient zero-sequence voltage and current during arc-earth fault were obtained as follows: 1) The frequency of transient component in the zero-sequence voltage and current was mainly relevant to the leakage impedance of transformer,to-earth capacitances and capacitances between phases and not relevant to the neutral earthed;2) The zero-sequence transient currents of non-fault feeders and fault feeder have identical frequency,attenuation speed and so on.The intensity of non-fault feeders was directly proportional to the to-earth capacitance,and the intensity of the fault feeder is equal to sum of that of all non-fault feeders with opposite direction;3) As the single-phase earth fault occurs nearby the maximum value of phase voltage,the zero-sequence transient current was the largest.A new method,which can detect single-phase-to-ground fault feeder using a transient zero-sequence current direction,was proposed.The method can be operated in the single-chip micro-processor and locate the fault feeder on-time.The operation results indicate that this method can effectively raised the accuracy of the detecting fault feeder for arc-earth fault.

A NEW APPROACH ON DETECTING THE SINGLE-TO GROUND FAULT LOCATION ON POWER SYSTEM WITH NEUTRAL UNEARTHED

A new principle to detect the grounded line in a neutral point indirectly grounded power system based on the energy function

New Fault Locating Method Based on Transient Vector Field for Single Phase Grounding Fault in Non-solidly Earthed Overhead Lines

A New Approach and Its Realization for Identification of Distribution Network's Single Phase Grounding

Study of Accurate Single-phase Grounding Fault Location Based on Distributed Parameter Theory Using Data of Zero Sequence Components

Zero Sequence Current-based Fault Section Location of Distribution Network

A New Non-contact Approach for Fault Current Measurement of Non-solidly Earthed Overhead Lines

Method of Fault Line Location and Its Implementation

Fault line selection of single-phase to ground based on negative sequence current pilot differential in distribution network

Single Phase to Ground Fault Section Location Based on Transient Signals in Non-solidly Earthed Network

Fault Location of Single-Phase-to-Ground in Neutral Point Ungrounded System

Single phase to ground fault location based on electromagnetic field in non-solidly earthed network

Single-Phase Earth Fault Location Method Based on Harmonic Analysis for the Nugs

Study of Detecting Single-Phase-to-Ground Fault Feeder Using a Transient Current Direction

New Approach to Detect Fault Line in Resonant Grounded System Based on HHT and SVM

A novel fault locator for power distribution system with neutral non-effectively grounded

A data-driven method to detect and localize the single-phase grounding fault in distribution network based on synchronized phasor measurement

Single-phase-to-ground Fault Location Based on Transient Fault Signal and Its Attenuation Character for Distribution Network

Fault Location In Neutral Non-Effectively Grounded Distribution Systems Using Phase Current And Line-To-Line Voltage

Identification and Simulation of Single-Phase Grounding Fault in Neutral Point Insulation System

Detecting Single-Phase-to-ground Faulted Feeder in Resonant Grounded Power Distribution System