Abstract:Purpose – The purpose of this paper is to propose a new three-phase switched reluctance motor (SRM), and achieve high-torque and low-cost. This new SRM's winding configuration uses the double-layer distributed windings, which is different from the conventional SRM's single tooth coils. Design/methodology/approach – The operating principle of new SRM is analyzed, and the voltage equation and the generated torque are deduced. Finite element method (FEM) and finite element circuit coupled method are utilized to evaluate the new motor's operating performances. The two dimensional (2D) frequency response analysis model is employed in the FEM model. Based on the 2D frequency response analysis model, the magnetic field distribution, self-inductance, and mutual-inductance for the new SRM are analyzed in detail. A co-simulation model using FE analysis package and Matlab-Simulink is proposed to simulate the new SRM drive. The simulated and experimental results verify the new SRM. Findings – For the new SRM with double-layer distributed windings, a co-simulation method is proposed to analyze its characteristics. The new SRM presents lower torque ripple coefficient and generates larger torque than the conventional SRM, with three-wire and standard full bridge power converter, rather than six-wire and asymmetric half-bridge converter for conventional SRM. Originality/value – This paper proposes a new SRM with the double-layer distributed windings driven by a standard full bridge inverter. In order to calculate dynamic characteristics of the new SRM, a co-simulation method using FEM and Simulink is proposed to simulate the new SRM drive, where the power inverter and the current chopping control algorithm are implemented.

Simulation Study of a Novel Stator Structure of the Switched Reluctance Motor (SRM) and Its Eletromagnetism Relations

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Design and Torque Optimization of Single-phase Hybrid Switched Reluctance Motors

Simulation Study of SRM Stator Pole Structure with FEM

Research on a Novel Axial Field Disk Type Switched Reluctance Motor

A Novel Boost Chopper Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

The Simulation on Switched Reluctance Motor Driver

A Novel Dead-Beat Torque Control of Switched Reluctance Machines

Investigation on Different Stator Structures of the Axial-Radial Flux Switched Reluctance Motors

Torque Analytical Model of Switched Reluctance Motor Considering Magnetic Saturation

Investigation of Skewing Effects on the Vibration Reduction of Three-Phase Switched Reluctance Motors

Design of a Low-Ripple Double-Modular-Stator Switched Reluctance Machine for Electric Vehicle Applications

Characteristics Evaluation of a Segmental Rotor Type Switched Reluctance Motor with Concentrated Winding for Torque Density and Efficiency Improvement

A New Switched Reluctance Motor with Distributed Winding

Design and analysis on switched reluctance motor system using field-circuit coupled method

On The Magnetic Behavior And Steady-State Performance Estimation Of A Bipolar Excited Switched Reluctance Machine

Design and Performance Analysis of a Switched Reluctance Motor Using Finite Element Analysis and Magnetic Equivalent Circuit Model

Magnetic Suspension Performance Analysis of a Bearingless Switched Reluctance Motor

Study of the new permanent magnet switched reluctance motor

Analysis and Design of Synchronous Reluctance MachinesPart Ⅹ:Combination of Stators and Rotors of Synchronous Reluctance Machine and Switched Reluctance Machine

DSSRM Design with Multiple Pole Arcs Optimization for High Torque and Low Torque Ripple Applications