Abstract:Natural rubber is a widely used elastomer for the preparation of cyclically mechanically loaded products such as tires, where it reduces self-heating behavior. From a material point of view, the degree of self-heating depends on the composition of the rubber compound. One of the parameters influencing the self-heating of rubber is the type of curing system, which leads to different crosslinking density. The crosslinking density value for carbon black filled rubbers is only apparent due to the its physical interactions present and is referred to as the apparent crosslinking density (aCLD).Therefore, this work focuses on investigating the effect of sulfur intermolecular network formation by conventional (CV), semi-efficient (SEV) and efficient (EV) curing systems on the temperature development of cyclically loaded rubber using an advanced test method to in-situ determine the heat build-up. Rubber samples based on different curing systems were prepared by varying the concentration of the accelerator N-Tertiarybutyl-2-benzothiazole sulfenamide (TBBS) at a constant concentration of sulfur (2.5 phr). Using basic mechanical tests, it was found that the stiffness and hardness of the rubber increased with increasing aCLD and decreasing proportion of poly-sulfide bonds, respectively. Furthermore, cyclic mechanical analysis showed that with increasing aCLD and parallel decrease in the proportion of poly-sulfide bonds, both the loss modulus ( G'' ) and dissipated strain energy increased, which was also reflected in the values of the mechanical stress-induced self-heating gradient. From the values of maximum developed temperatures, it was evident that the group of material with CV curing system showed the lowest self-heat build-up.

Effect of Crosslink Structure on Mechanical Properties of Natural Rubber Vulcanizate under Different Aging Conditions

Effect of Crosslink Structures on Dynamic Mechanical Properties of Natural Rubber Vulcanizates under Different Aging Conditions

Effect of ageing on NR vulcanizates

Effect of high-temperature curing on the crosslink structures and dynamic mechanical properties of gum and N330-filled natural rubber vulcanizates

Effect Of Vulcanization Systems And Crosslink Density On Tensile Properties And Network Structures Of Natural Rubber

Effect of non-rubber components on the crosslinking structure and thermo-oxidative degradation of natural rubber

Thermo-oxidative degradation behavior of natural rubber vulcanized by different curing systems

Thermal Aging on Mechanical Properties and Crosslinked Network of Natural Rubber/Zinc Dimethacrylate Composites

Influences of different reinforcing agents on properties of hydrogenated nitrile rubber vulcanizate

Investigation of Crosslinking in the Thermooxidative Aging of Nitrile–butadiene Rubber

Influence of Hot-Oxygen Aging on Crosslink Structure and Mechanical Performances of NR Vulcanite

Effect of the Curing Systems on Mechanical Behaviour of Natural Rubber Composites

Influence of Different Curing Systems on Static and Dynamic Properties of NR Vulcanizates

Microstructure Evolution and Strain Softening of Carbon Black Filled Natural Rubber Vulcanizates

Influence of amount of sulfur on crosslinking density and structure of natural rubber characterized by nuclear magnetic resonance spectroscopy

Effect of the cure system on aging resistance of natural rubber compounds

Studies On Thermo-Oxidative Aging Mechanism Of Natural Rubber By Two Dimensional Correlation Infrared Spectrum Method And The Standard Linear Solid Model

The design of crosslinks in different vulcanized systems to improve crack growth resistance for carbon black/graphene oxide/natural rubber composites

The Effect of Apparent Density of Sulfidic Crosslink and Their Chemical Nature on Self-heat Build-up in Carbon Black Filled Natural Rubber under Cyclic Mechanical Loading

Influence of Prolonging Vulcanization on the Structure and Properties of Hard Rubber