Abstract:CuO-ZnO catalysts for sorbitol hydrogenolysis were prepared by co-precipitation method, and the effects of CuO/ZnO molar ratio, precipitation temperature and pH value on the performance of CuO-ZnO catalyst prepared were investigated. The H2-TPR, SEM and XRD were used to examine the reduction property, surface morphology and the crystal phase of the catalysts. Using the CuO-ZnO catalyst prepared with molar ratio of CuO to ZnO equal to one, precipitation temperature of 70℃ and pH of 8.0, and under the hydrogenolysis conditions of temperature equal to 200℃, pressure of 11.80 MPa and reaction time of 5 h, the best catalytic activity with the conversion ratio of sorbitol equal to 86.42% and yield of C4～C6 polyols equal to 59.18% can be achieved. It was found that CuO is the active component of the CuO-ZnO catalyst for sorbitol hydrogenolysis and both the molar ratio of CuO to ZnO and the content of CuO in the catalysts affect the catalytic performance significantly. The function of ZnO in the catalyst is to disperse CuO and to adsorb and activate hydrogen, and then enhances the reducibility of CuO and improves the hydrogenolysis of sorbitol. In addition, during preparation, the precipitation temperature and pH might exert remarkable effects on the catalyst performance through determining the formation of phase morphology and crystallinity of the catalyst prepared.

STUDIES ON PREPARATION RULES OF CuO/ZnO CATALYST FOR METHANOL SYNTHESIS BY CARBON DIOXIDE HYDROGENATION

PREPARATION OF CuO/ZnO CATALYST FOR METHANOL SYNTHESIS BY CARBON DIOXIDE HYDROGENATION I. Preparation Methods

Effects of CuO/ZnO Ratio and Preparation Conditions on Performance of CuO-ZnO Catalysts in Preparing C4～C6 Polyols through Sorbitol Hydrogenolysis

A practical approach for the preparation of high activity Cu/ZnO/ZrO2 catalyst for methanol synthesis from CO2 hydrogenation

Studies on the coprecipitation mechanism of Cu/ZnO catalysts for methanol synthesis from carbon dioxide

Preparing methods of CuO/ZnO/Al2O3 catalysts for the synthesis of methanol

Influences of preparation methods of ZrO2 support and treatment conditions of Cu/ZrO2 catalysts on synthesis of methanol via CO hydrogenation

Methanol Synthesis from CO 2 Hydrogenation on CuO–ZnO–ZrO 2 Prepared by Solvothermal Method: the Influence of Solvent on Catalyst Properties and Catalytic Behavior

Solvothermal Preparation of CuO-ZnO-ZrO2 Catalysts for Methanol Synthesis Via CO2 Hydrogenation

Preparation of CuO-ZnO-ZrO2 by Citric Acid Combustion Method and Its Catalytic Property for Methanol Synthesis from CO2 Hydrogenation

CO2 Hydrogenation to Methanol over Cu/ZnO/ZrO2 Catalysts Prepared Via a Route of Solid-State Reaction

Preparation of Cu/ZnO/Al2O3 Catalysts in a Solvent-Free Routine for CO Hydrogenation

Preparation of CuO/ZnO/Al2O3 Catalysts for Methanol Synthesis Using Parallel-Slurry-mixing Method

A High Activity Cu/ZnO/Al2O3 Catalyst for Methanol Synthesis: Preparation and Catalytic Properties

XPS Studies of Cu/ZnO/Al2O3 Ultra-Fine Catalysts Derived by a Novel Gel Oxalate Co-Precipitation for Methanol Synthesis by CO2+H2

ChemInform Abstract: A Novel Process for Preparation of a Cu/ZnO/Al2O3 Ultrafine Catalyst for Methanol Synthesis from CO2 + H2: Comparison of Various Preparation Methods.

Synthesis, characterization and activity pattern of Cu–ZnO/ZrO2 catalysts in the hydrogenation of carbon dioxide to methanol

DUAL PROMOTION OF Cu/ZnO CATALYSTS MODIFIED BY ACETYLACETONE PRECURSORS FOR CO2 HYDROGENATION TO METHANOL

Performance of Cu-Mn-Zn/ZrO2 catalysts for methanol synthesis from CO2 hydrogenation: The effect of Zn content

Study of Preparing Conditions of Methanol Liquid Oxidative Carbonylation to Dimethyl Carbonate

In Situ Spectroscopic Characterization and Theoretical Calculations Identify Partially Reduced ZnO<sub>1-<i>x</i></sub>/Cu Interfaces for Methanol Synthesis from CO<sub>2</sub>