Abstract:In this study, a framework to determine the dynamic flow stress equation of materials based on discrete data of varied (or instantaneous) strain-rate from split Hopkinson pressure bar (SHPB) experiments is proposed. The conventional constant strain-rate requirement in SHPB test is purposely relaxed to generate rich dynamic flow stress data which are widely and diversely distributed in plastic strain and strain-rate space. Two groups of independent SHPB tests, i.e. Group A (without shaper) and Group B (with shaper) were conducted on the C54400 phosphor-bronze copper alloy at room temperature, obtaining flow stress data (FSD) (two-dimensional (2D) matrix). Data qualification criteria were proposed to screen the FSD, with which qualified FSD were obtained. The qualified FSD of Group A were coarsely filled with missing data and were reconstructed by the Artificial Neural Network (ANN). As a result, finely-filled FSD of Group A were obtained, which were carefully evaluated by the qualified FSD of Group B. The evaluation proves the effectiveness of ANN in FSD prediction. Next, the finely-filled FSD from Group A were decomposed by Singular Value Decomposition (SVD) method. Discrete and analytical flow stress equation f(strain, strain-rate)_ana were obtained from the SVD results. Finally, flow stress equation (f(strain, strain-rate)_MJC) based on conventional method were established. Five uncertainties inherent in the conventional method in the determination of the flow stress equation were identified. The comparison between f(strain, strain-rate)_ana and f(strain, strain-rate)_MJC demonstrated the effectiveness and reliability of the flow stress equation obtained from the proposed method.

Prediction of first normal stress difference during extrusion flow of tube compound

Comparative analysis of flow factors and crystallinity in conventional extrusion and gas-assisted extrusion

Comparison of Hydrostatic Extrusion Between Pressure-Load and Displacement-Load Models

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Complex Stress-Strain Relations of Tubular Materials Studied with A Flexible Hydroforming System

Prediction of Flow Stress and Characterizing the Deformation Mechanism of As‐extruded 7005 Aluminum Alloy

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion

Extrusion forming simulation of microchannel flat tube and welding quality prediction

Analytical Model for Tube Hydro-Forging: Prediction of Die Closing Force, Wall Thickness and Contact Stress

Determination of dynamic flow stress equation based on discrete experimental data: Part 1 Methodology and the dependence of dynamic flow stress on strain-rate

Study on the Melt Rheological Characterization of Micro-Tube Gas-Assisted Extrusion Based on the Cross-Scale Viscoelastic Model

Flow Stress Model Development and Hot Extrusion Simulation for Liquidus Casting ZK60 Magnesium Alloy

Hot Extrusion Simulation for AZ31B Mg Alloy Tubes and Construction of Extrusion Limit Diagram

Prediction of flow stress of Mg–Nd–Zn–Zr alloy during hot compression

Discussion and Prediction on Decreasing Flow Stress Scale Effect

Predictive modeling of Loading paths for Hydroforming of bi-layered Y-shaped tubes

Modeling Hydraulically Expanded Tube-To-Tubesheet Joint Based on General Stress-Strain Curves of Tube and Tubesheet Materials

A method to predict flow stress considering dynamic recrystallization during hot deformation

Experimental Verification of the Influence of Normal Stress on the Formability of Thin-Walled 5a02 Aluminum Alloy Tubes

Rheological Characterizations and Extrudate Swell Predictions of an LDPE Melt by Two KBKZ-type Constitutive Equations

Deformation characteristic and prediction of flow stress for as-cast 21Cr economical duplex stainless steel under hot compression