Estimation of Quality of Seam Welds in AlMgSi(Cu) Extrusion by Using an Original Device for Weldability Testing
Marek Bogusz,Dariusz Leśniak,Józef Zasadziński,Wojciech Libura,Beata Leszczyńska-Madej,Jacek Madura,Tomasz Latos,Kamila Limanówka,Bartłomiej Płonka
DOI: https://doi.org/10.3390/ma17225448
IF: 3.4
2024-11-08
Materials
Abstract:Extrusion welding of AlMgSi(Cu) alloys is carried out by using porthole dies, as a result of which hollow shapes are formed with longitudinal seam welds. In the case of the inappropriate selection of the chemical composition of the aluminium alloy or improper metal welding conditions, the weld may have reduced strength in relation to that of the base material, thus weakening the strength of structures based on aluminium extrudates. The prediction of metal welding conditions, depending on the chemical composition of the alloy, the temperature and the unit welding pressures, effectively supports the design of porthole dies, thus significantly reducing the number of necessary extrusion tests and die geometry corrections needed during its implementation in industrial practice, and consequently significantly reducing production costs. In this work, an original laboratory test device simulating the behaviour of metal in a welding chamber of a porthole die was applied to examine the ability of AlMgSi(Cu) alloys to produce high-quality joints. Two different chemical compositions of AlMgSi(Cu) aluminium alloys differing in Mg, Si and Cu contents were used: alloy no. 1A (0.68% wt. Mg, 1.04% wt. Si, 0.61% wt. Cu) and alloy no. 3A (0.8% wt. Mg, 1.21% wt. Si, 1.22% wt. Cu). The weldability tests were carried out under various welding temperatures of 450, 500 and 550 °C and under various welding pressures of 150 MPa, 250 MPa and 350 MPa. The microstructural changes in the produced welds were evaluated with the use of OM and SEM/EDS with chemical analysis in micro-areas, whereas the mechanical effects were evaluated by using a static tensile test. Samples after static tensile testing were subjected to fractographic tests to determine the nature of the fractures. The highest values of relative weld strength were obtained under the highest welding temperature of 550 °C and the highest unit welding pressure of 350 MPa: 87% for alloy number 1/1A (high-strength weld), and 62% for alloy number 6/3A (medium-strength weld). Finally, the extrusion tests were performed in industrial conditions with an examination of the EBSD structure and strength of the longitudinal welds. High values of relative weld strength for extrudates from alloy no. 1/1A and alloy no. 3A, 96% and 89%, respectively, were found, which confirmed the previous weldability testing results.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering