Abstract:Recent studies on jet penetration height in literature were reviewed. Double-jet penetration in fluidized beds was investigated both experimentally and numerically. The experimental investigation was performed in a 300×51 mm two-dimensional gas–solids fluidized bed with two vertical jets, and the jet penetration height was measured. Different kinds of particles were tested in turn. The numerically predicted jet penetration heights were from the solution of a hydrodynamic model describing the gas–solids fluidization. The hydrodynamic model is based on the kinetic theory for fluidization and K–εk turbulence model for gas phase. The governing partial differential equations were solved using the modified Inter Phase Slip Algorithm (IPSA) method. The formation mechanism of jets was analyzed and the interaction of two vertical jets was reconstructed using this model. Numerical results indicated that the flow pattern of a two-jet system could be classified into three categories: isolated jets, transitional jets, and interacting jets. The criterions for those flow regions were found. The effects of jet characteristics (jet velocity, nozzle width, and the distance between two jets), particle properties (particle diameter, particle sphericity, and particle density), fluidizing gas characteristics (superficial gas velocity of bed, inlet gas density, and gas viscosity), and bed height on the jet penetration height were analyzed. It was found that the dominant factors affecting the jet penetration height are jet momentum, the drag between the two phases, entrainment near the jet neck, the distance between two jets, and the superficial gas velocity. Thus, the Froude number, Reynolds number, superficial gas velocity, the distance between the two jets, and jet nozzle width are used to propose algebraic empirical equations to estimate the jet penetration height of gas–solids fluidization at different jet regions. The empirical equations were compared with published experimental data or correlations.

Penetration Depth in a Jetting Fluidized Bed with Different Annular Velocity

Hydrodynamic characteristics of a two-dimensional jetting fluidized bed with binary mixtures

The jet penetration depth in a fluidized bed of multi-component particles

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Particle Decelerating Regions in Turbulent Fluidized Bed

Flow Characteristics in A Large Jetting Fluidized Bed with Two Nozzles

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Characterization of Particle Fluidization Pattern in a Gas Solid Fluidized Bed Based on Acoustic Emission (AE) Measurement

FLOW REGIME TRANSITION AND PENETRATION DEPTH OF LARGE JETTING FLUIDIZED BED

On the jet penetration height in fluidized beds with two vertical jets

Experimental Investigation On Secondary Air Jet Penetration Depth In The Dense Zone Of A Circulating Fluidized Bed

Measurement of the Fluidized Velocity in Gas-Solid Fluidized Beds Based on AE Signal Analysis by Wavelet Packet Transform

Particle Motion in Two‐ and Three‐Phase Fluidized‐Bed Reactors Determined by Pulsed Field Gradient Nuclear Magnetic Resonance

Study of Air Jet Penetration in a Fluidized Bed

HYDRODYNAMIC CHARACTERISTICS IN LARGE JETTING FLUIDIZED BED WITH DOUBLE NOZZLES

Study on Jet Flow from Two Vertical Nozzles in A 500 Mm Id Semi-Circular Fluidized Bed

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Hydrodynamics of Large Jetting Fluidized Bed.

Gas Discharge Patterns in a Large Jetting Fluidized Bed with a Vertical Nozzle

EXPERIMENTAL STUDY ON JET PENETRATION ANDCOALESCENCE FROM TWO VERTICAL NOZZLES IN ASEMI-CIRCULAR FLUIDIZED BED