Abstract:To provide good light sources of narrow linewidth for coherent optical communication systems we have proposed a new type of external cavity semiconductor laser with multisegment cavity structure.1 Its advantages are: (1) stable single longitudinal mode operation with high side-mode suppression ratio is easily obtained; (2) two-branch output beams standing in direction can be used. In this paper we report a practical device with multisegment cavity configuration, which basically consists of a 1.5-μm antireflection coated laser diode (LD) coupled by a graded-index (GRIN) lens to a thin Fabry-Perot etalon. The etalon is fixed on a piezoelectric transducer (PZT) and its angle of inclination can be adjusted by three fine screws for laser wavelength tuning and for optimization of alignment. The facet reflectivities of the LD, GRIN lens, and F.P. etalon are matched for achieving good single longitudinal mode oscillation. Analyses and experiments indicate that the frequency instability originates mainly from the fluctuation of the environmental temperature and mechanical disturbances in external cavity lasers.2 To reduce these effects all components are stuck on a microcrystal glass plate with low expansion coefficient and their interthermal expansions are compensated, i.e., 2αi,Li ≈ 0, where αi, and Li, are the thermal expansion coefficient and lengths of each component, respectively. The LD temperature is controlled within 0.1°C using a small Peltier cooler. All the components are put in a copper box. The device size is 32 × 26 × 65 mm3 and the actual cavity length is 2-4 cm.

Numerical Analysis of Semiconductor Lasers with Fbg External Cavity Reflectors

Analysis and Design of Combined Distributed-Feedback/fabry-perot Structures for Surface-Emitting Semiconductor Lasers

Nonlinear Phenomena Analysis of Tunable External Cavity Semiconductor Laser with Sampled Fiber Grating

Numerical simulation of linewidth compression dynamics of external-cavity semiconductor laser

Thermal analysis of 980-nm optically pumped vertical-external-cavity surface emitting lasers with DBM structure: Finite element method

Steady-State Numerical Model For Sg-Dbr Lasers

Narrow-linewidth external cavity semiconductor laser based on permanent index modulated grating optical feedback for radiation resistance

Influence of External Cavity Feedback on the Oscillating Characteristics of A Semiconductor Laser

Optimum End Reflectivity in External Semiconductor Lasers

Travelling wave analysis on high-speed performance of Q-modulated distributed feedback laser.

Analysis on Steady-State Characteristics of Widely Tunable SG-DBR Laser with Residual Facet Reflectivity Model

Research on Narrow Line Width External Cavity 846 nm Semiconductor Laser

High power external cavity semiconductor laser

Design studies for distributed Bragg reflectors for short-cavity edge-emitting lasers

Practical Multisegment Composite-Cavity Semiconductor Lasers

Linear polarization and narrow-linewidth external-cavity semiconductor laser based on birefringent Bragg grating optical feedback

Thermal Tunable Narrow Linewidth External Cavity Laser with Thermal Enhanced Fbg

975 nm multimode semiconductor lasers with high-order Bragg diffraction gratings

Design of 780 Nm External Cavity Semiconductor Laser and Higher Harmonic Frequency Stabilization

Numerical investigation of vertical-cavity surface-emitting lasers incorporating a high-contrast grating using 3-D FDTD method

Single-mode Characteristics of Short Coupled-Cavity Semiconductor Lasers