Abstract:Abstract This paper presents a complete study about three-dimensional (3-D) flow field development in a linear compressor cascade where flow field in the blade passage has been studied experimentally as well as numerically. In the experimental work, a linear compressor cascade test section was installed in an open loop wind tunnel. The experimental data was acquired for a Reynolds number of 2.98 × 105 based on the blade chord and the inlet flow conditions. The flow field characteristics in blade passage including 3-D flow velocity and velocity magnitude have been measured by using calibrated five and seven-hole pressure probes connected to ATX sensor module data acquisition system (DAQ). To investigate flow development in the blade passage, velocity coefficient through streamwise planes has been calculated from the measured data. The computational fluid dynamics (CFD) study of the flow field was performed to gain a better understanding of the flow features. Present computational study was first validated with previous experimental and numerical work to check mesh accuracy and give confidence for computational results. Then, two turbulence models, Spalart-Allmaras (S-A) and shear stress transport SST (k-ω) were used for the present work. From both parts of study, the flow field development through the cascade have been investigated and compared. Moreover, the received data demonstrated a good agreement between the experimental and computational results. The predicted flow streamlines by numerical calculations showed regions characterized by flow separation and recirculation zones such as corner separation that could be used to enhance the understanding of the loss mechanism in compressor cascades. All measurements taken by the two probes, 5 and 7-hole pressure probes, have been analyzed and compared. The 5-hole pressure probe measurements have showed more agreements with computational results than 7-hole probe. Furthermore S-A turbulence model calculations showed more consistencies with experimental results than SST (k-ω) model.

DISCUSSION ON THE GEOMETRY AND THE SECONDARY FLOW VORTEX STRUCTURE OF KRAIN'S EXPERI-MENTAL COMPRESSOR IMPELLER

Numerical simulation of internal flow in forward-curved centrifugal fan

Analysis of flow characteristics in the volute casing of centrifugal pump based on numerical simulation

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

The Use of the 3D-Viscous Codes in the Analysis of High Speed High Pressure Ratio Centrifugal Impellers

Experimental And Numerical Investigation Of The Flow Field In The Radial Inlet Of A Centrifugal Compressor

NUMERICLE STUDY OF THE FLOW INSIDE THE NASA 'S LOW-SPEED CENTRIFUGAL COMPRESSOR IMPELLER

The experiment investigation of the flow field in centrifugal impeller

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

CFD ANALYSIS AND RESULT VALIDATION OF A CERTAIN CENTRIFUGAL COMPRESSOR IMPELLER

Flow Structure in Impeller Backside Cavity and its Effect on Aerodynamic Performance of a Centrifugal Compressor

Study of Three-Dimensional Viscous Flow Field in Axial-Flow Fan

Investigations of Three-Dimensional Flow Field Development in an Axial Compressor Cascade

Experimental and Computational Investigation of A Centrifugal Compressor Stage

Study on flows through centrifugal pump impeller by turbulent simulation

Simulation of the Inlet Flow of a Centrifugal Compressor Impeller with and Without a Spinner

Investigation of flow pattern and hydraulic performance of a centrifugal pump impeller through the PIV method

COMPUTATION AND ANALYSIS ON THE IMPELLER BACKSIDE CAVITY OF A CENTRIFUGAL COMPRESSOR

Computer 3D Vision Aided Full-3D Optimization of a Centrifugal Impeller

Numerical method for three-dimensional internal flows and its analysis in a radial inflow turbine impeller