Abstract:Hypothesis: In terms of the Young's equation, the temperature dependence of liquid-solid contact angle is affected by the surface material, so the wetting behavior could be tuned by both changing the tempera -ture and surface material. However, the synergistic effects of surface material and temperature on the water contact angle remain unclear, especially at elevated temperatures. Experiments: In this study, a systematic characterization of water contact angle against various smooth metallic and nonmetallic surfaces was conducted for temperatures up to 300 t in a high-pressure cham-ber at 15 MPa. The measured results were finally compared with the predictions made by the sharp-kink approximation model. Findings: Not surprisingly, it was observed the temperature-dependent water contact angle is sensitive to the type of solid surface. The temperature coefficients and critical temperature points on the contact-angle-temperature curves can be manipulated by altering the surface material. However, the influence of surface material is weakened by raising temperature, thus leading to the nearly consistent temperature-dependent water contact angle over 120t. Additionally, the necessity of investigating the internal flows within the water drops was highlighted to unravel the positive temperature correlation of the water contact angle at high temperatures, in view of the presence of non-spherical-cap-shaped drops. (c) 2021 Elsevier Inc. All rights reserved.

CORRELATION AND CALCULATION OF THE SURFACE TENSION DATA OF MELTING METALLIC SUB STANCES AT SATURATION CONDITIONS

CORRELATION AND CALCULATION OF THE SURFACE TENSION DATA OF QUANTUM FLUIDS AT LOW TEMPERATURES

Melting-pressure and Density Equations Ofhe3at Temperatures From0.001to30

Unraveling the Synergistic Effects of Solid Surface Material and Temperature on the Contact Angle of Water under an Elevated Pressure: an Experimental Study

Temperature dependence of contact angles of water on a stainless steel surface at elevated temperatures and pressures: In situ characterization and thermodynamic analysis.

Application of the The ory of Molecular Aggregation to Ca lculate the Thermodynamic properti es of Melting Metallic Substances

Temperature Dependence of the Dynamic Contact Angles of Water on a Smooth Stainless-Steel Surface under Elevated Pressures

Investigation of Surface Properties for Electrolyte Solutions: Measurement and Prediction of Surface Tension for Aqueous Concentrated Electrolyte Solutions

Measurement principles for room temperature liquid and fusible metals' surface tension

Corresponding-state model for predicting surface tension

CALCULATION OF SURFACE TENSION WITH GRADIENT THEORY FOR NORMAL MIXTURES AND MIXTURES CONTAINING A SUPERCRITICAL COMPONENT

Empirical correlation of the surface tension versus the viscosity for saturated normal liquids

A Corresponding-state Model for Predicting Surface Tension

A Monte Carlo Simulation on Surface Tension of Liquid Nickel

Prediction of the surface and interface stress of metallic elements

Surface Tension for Aqueous Electrolyte Solutions by the Modified Mean Spherical Approximation

Surface Tension of Liquid Ternary Fe-Cu-Mo Alloys Measured by Electromagnetic Levitation Oscillating Drop Method.

A model for work of solid–liquid adhesion in multicomponent melts

Surface Tension Correlation for Binary HFC Mixtures

Surface free energies of solid metals: Estimation from liquid surface tension measurements

Calculation of surface tensions for liquid mixtures using the SWCF‐VR EOS and Butler‐type method