Abstract:The inductance model used in traditional sensorless control methods for switched reluctance machines (SRMs) exhibits high-order harmonics. The precision of the motor may be impacted by the buildup of rotor estimate errors caused by these harmonics. To address this issue, this paper proposes a novel method for SRMs that employs a hybrid algorithm combining an enhanced second-order generalized integrator (SOGI)-based frequency-locked loop (FLL) and an active disturbance rejection control (ADRC)-based phase-locked loop (PLL). This approach involves coordinate transformation and parameter identification to reconstruct the motor inductance model. Rotor position errors are calculated using the unsaturated inductance difference method. In order to enhance the accuracy of motor position estimation, a hybrid algorithm is employed to efficiently filter out harmonic errors and mitigate the tremor effect caused by the rotor position differential algorithm. This hybrid algorithm enables the estimate of the motor's speed and rotor position. A sensorless control simulation model was developed using a 12/8 pole SRM to assess the motor's performance under varying load conditions. Based on the results obtained, it is established that the application of this method can accurately estimate the rotor's position and rotational speed and thus improve the performance of position sensorless control. Ultimately, a prototype system for a switched reluctance motor was created, and the effectiveness and feasibility of the proposed control technique were confirmed through experimental validation. This presents an innovative approach to engineering practice.

POSITIONS DETECTION AND FORECAST OF SENSORLESS SWITCHED RELUCTANCE MOTOR

SWITCHED RELUCTANCE MOTOR SENSORLESS DRIVE WITH ENERGY OPTIMIZING CONTROL STRATEGY

Versatile Sensorless Drive of Switched Reluctance Motor

Position Sensorless Control For Pmsm Using Sliding Mode Observer And Phase-Locked Loop

Sensorless SRD System Based on the Derivative Change of Phase Current

Analysis of Position Errors in High-Frequency Carrier Signal Injection Based Sensorless Control of PMSM

Online Sensorless Position Estimation for Switched Reluctance Motors Using One Current Sensor

Indirect Position Control of High Speed Switched Reluctance Motor

Position-Sensorless Control of Switched Reluctance Motor Drives: A Review

Four-Quadrant Position Sensorless Operation of Switched Reluctance Machine for Electric Vehicles Over a Wide Speed Range

Sensorless control and start-up strategy of permanent magnet synchronous motor

Flexible Sensorless Position Control of Switched Reluctance Motors considering Both Embrace Design and Magnetic Saturation

Waveform Detection Technique for Indirect Rotor-Position Sensing of Switched-Reluctance Motor Drives. I. Analysis

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Wave-Form Detection Technique for Indirect Rotor-Position Sensing of Switched-Reluctance Motor-Drives .2. Experimental Results

Position Sensorless Control of Switched Reluctance Motor Drives Based on a New Sliding Mode Observer Using Fourier Flux Linkage Model

Position Sensorless Control of Switched Reluctance Motors Using Reference and Virtual Flux Linkage With One-Phase Current Sensor in Medium and High Speed

The Study of SRM Sensorless Control Strategy Based on SOGI-FLL and ADRC-PLL Hybrid Algorithm

Implementation of a new position sensorless control technique for switched reluctance motor drives

Switched Reluctance Motor Drive Without Direct Rotor Position Sensing

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings