Synthesis of ZSM-5 Zeolite Membrane and Its Influencing Factors by a Novel Method

张雄福,王金渠,殷德宏,刘长厚
DOI: https://doi.org/10.3321/j.issn:0253-9837.2000.05.019
IF: 16.5
2000-01-01
Chinese Journal of Catalysis
Abstract:Most zeolite membranes are obtained by conventional hydrothermal synthesis in recent years. However, there exit some problems, such as severe pretreatment of substrates, complicated operation process and the synthesized membrane with some defects. In this paper, ZSM 5 zeolite membranes were prepared by in situ hydrothermal synthesis on porous α Al 2O 3 tubes coated with ZSM 5 seeds by using spraying method. A colloidal ZSM 5 suspension was prepared by dispersing the ZSM 5 seeds in silica sol at concentration of 0.8%~1.0%. During the hydrothermal treatment, a continuous ZSM 5 zeolite membrane was formed. The ZSM 5 zeolite membrane was characterized by XRD, SEM and single gas permeation measurement. Some parameters, such as the concentration of SiO 2 and seeds and the quality of seed crystals in the colloidal suspension, were investigated in detail. It has been shown that the suitable concentration of SiO 2 and seeds and smaller, uniform seed crystals are beneficial to the formation of a continuous smooth coating layer, which is suitable for the formation of defect free ZSM 5 zeolite membrane. The performance of the ZSM 5 zeolite membrane synthesized by using spraying seed coating method is much better than that of the ZSM 5 zeolite membrane synthesized by using the conventional hydrothermal method. The permeability for H 2 is 2.70 μmol/(s·m 2·Pa), the separation factor for H 2/C 3H 8 is as high as above 14 through the membrane synthesized by using the spraying seed coating method. This technique is especially suitable for the industrial synthesis of zeolite membranes.
What problem does this paper attempt to address?