Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Similarity in Radial Profiles of Solids Fraction in Bubbling and Turbulent Fluidized Bed

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Radial solids fraction profiles in inlet region of high density circulating fluidized bed

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Radial profile of the solid fraction in a liquid-solid circulating fluidized bed

Profiles of particle velocity and solids fraction in a high-density riser

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Bubble Characterization in the Gas-Solid Fluidized Bed Using an Intrusive Acoustic Emission Sensor Array

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Radial Profiles of Solids Concentration and Velocity in a Very Fine Particle (36 Μm) Riser

PARTICLE VELOCITY FIELD IN LIQUID-SOLID CIRCULATING FLUIDIZED BEDS

Transient Density Signal Analysis and Two-Phase Micro-Structure Flow in Gas–solids Fluidization

Bubble Dynamics and Particle Orientation in a Binary Fluidized Bed Containing Spherocylinders and Spheres

ANALYSIS OF FLOW STRUCTURE IN LARGE-SCALE CIRCULATING FLUIDIZED BEDS

Model and Experimental Study of Relationship Between Solid Fraction and Back-Mixing in a Fluidized Bed

Mass flux profiles in a high density circulating fluidized bed

Dispersion of lateral and axial solids in a cocurrent downflow circulating fluidized bed

Gas and Solids Mixing in A Turbulent Fluidized Bed