Abstract:The density and volumetric behavior of three typical n-alkanes (hexane, octane, and decane) influenced by different mole fractions of CO2 injected in them at temperatures from 303 to 363 K and pressures from 3.8 to 8.67 MPa were investigated by performing molecular dynamics simulations. It is shown that the mass density first increases and then decreases with increasing CO2 mole fraction. Correspondingly, the system volume only slightly swells at low CO2 contents while suddenly expanding when the CO2 mole fraction exceeds a value of ∼60%. The calculations of structural properties and interaction energies indicate that at low CO2 mole fractions, there are a few CO2 molecules existing in the gap of alkane molecules, resulting in poor compressibility, while at higher CO2 concentrations, the CO2 molecules begin to separate from the CO2-saturated alkane phase and form a gas phase, leading to higher compressibility. Therefore, at high CO2 mole fractions, the system density and volume can more easily be changed by temperature and pressure than that at low CO2 mole fractions. In addition, since it is harder for alkanes with longer chains to separate from each other, the volume swelling decreases and the density increases with increasing carbon number of n-alkane chains. Finally, we found that the increase in CO2 mole fraction, temperature, and the decrease in alkane chain length would promote the diffusion of both CO2 and alkane molecules. However, the influence of pressure on molecular diffusion is very limited except when P = 8.67 MPa and T = 333 K, where CO2 is in the supercritical state. This work is helpful for understanding the density and volumetric behavior of n-alkane/CO2 mixtures at a molecular level and provides useful information for guiding carbon sequestration and CO2-enhanced oil recovery.

Simulation of studies for mixtures of methanol and different alkanes in supercritical condition

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation of multi-fluidized-bed in series for methanol to olefins

Molecular Dynamics Simulation of Liquid Methanol

Microscopic structure and interaction analysis for supercritical carbon dioxide-ethanol mixtures: a Monte Carlo simulation study.

Insight Into The Molecular Structure Of Huolinguole Lignite Via Supercritical Methanolysis And Ambient Characterisation

Structural and Hydrogen Bond Analysis for Supercritical Ethanol: A Molecular Simulation Study

A molecular dynamics investigation on sub/supercritical phase change for alcohol/ n -heptane mixtures

Study of Methanol Extraction from Saturated Alkanes: Solvent Screening, Liquid–Liquid Equilibrium Measurement, and Thermodynamic Simulation

A Multi-scale Computer Simulation of the Solvation Behavior of n-Alkane in Supercritical Carbon Dioxide

Molecular Dynamics Simulation and Theoretical Study on Heat Capacities of Supercritical H2O/CO2 Mixtures

Coarse-grained models for fluids and their mixtures: Comparison of Monte Carlo studies of their phase behavior with perturbation theory and experiment

A molecular dynamic study of evaporation/supercritical-transition inter-relationship and multicomponents interaction for alkane/alcohol droplets

A Computer Simulation Study On Self- And Cross-Aggregation Of Multiple Polar Species In Supercritical Carbon Dioxide

Adsorption and Separation of Alkane Mixtures in Cu-BTC

Molecular Simulation Study on the Density Behavior of n -Alkane/CO 2 Systems

Molecular dynamics simulations of transport and separation of supercritical carbon dioxide-alkane mixtures in supported membranes

Clustering and Micro-immiscibility in Alcohol-Water Mixtures: Evidence from Molecular Dynamics Simulations

Molecular Dynamics Simulation of Transport and Separation of Carbon Dioxide–Alkane Mixtures in a Nanoporous Membrane Under Sub- and Supercritical Conditions

Molecular Simulation of Adsorption and Separation of Binary Mixtures for Short Linear Alkanes in Zeolite

Simulation and computer modeling of asphaltene in different solvents on oil-water interfaces using a molecular dynamic methodology