Abstract:Heat-treatment processes to obtain carbide-free upper bainite, low bainite and low-temperature bainite in the 34MnSiCrAlNiMo medium-carbon steel were explored. Results show that in the steel bainite transformation mainly goes through three stages: short incubation, explosive nucleation and slow growth. When transformation temperature, T > Ms + 75 degrees C, upper bainite consisted of catenary bainitic ferrite and blocky retained austenite is obtained in the steel. When Ms + 10 degrees C < T < Ms + 75 degrees C, lower bainite is the main morphology composed of lath-like bainitic ferrite and flake-like retained austenite. When T < Ms + 10 degrees C, the lower bainite, also known as low-temperature bainite, is obtained, which contains much thinner lath-like bainitic ferrite and film-like retained austenite. Mechanical testing results show that the lower the transformation temperature is, the better comprehensive performance is. The low-temperature bainite has the very high tensile strength and impact toughness simultaneously. The lower bainite has lower tensile strength and higher impact toughness. The upper bainite has higher tensile strength and lower impact toughness. The big difference of the mechanical performance between these kinds of bainite is mainly caused by interface morphology, size, and phase interface structure of the bainitic ferrite and the retained austenite. Additionally, when the bainite transformation temperature is decreased, the high-angle misorientation fraction in packets of bainite ferrite plates is increased. High-angle misorientation between phase interfaces can prevent crack propagation, and thus improves impact toughness. (C) 2014 Elsevier Ltd. All rights reserved.

Bainite and martensite in 38Si2Mn2Mo steel

Bainite microstructure and its tempering stability of 70Si3MnCrMo steel

FINE STRUCTURE AND CRYSTALLOGRAPHY OF ISOTHERMAL LOWER BAINITE IN AN EXPERIMENTAL STEEL 38Si2mn2mo

Effect of Bainite Microstructure Types on Mechanical Properties of Low-carbon Si-Mn Steel

Precipitation Behavior of the Lower Bainitic Carbide in a Medium-Carbon Steel Containing Si, Mn and Mo

Low-temperature bainite in low-carbon steel

Microstructure Evolution of 0. 19C-1. 53Si-2. 54Mn Bainite Steel in Continuous Cooling Process

Ultrafine Bainite in the Surface Layer of 38CrMoAl Steel

Carbide-Free Bainite in Medium Carbon Steel

Microstructure and mechanical properties of 18Mn3Si2CrMo steel subjected to austempering at different temperatures below M s

Experimental and theoretical analysis of multiphase microstructure in a newly designed MnSiCrC quenched and partitioned steel to promote bainitic transformation: The significant impact on mechanical properties

Study on carbide-free bainite microstructure and mechanical properties of 70Si3Mn steel

Bainitic transformation during the two-step quenching and partitioning process in a medium carbon steel containing silicon

Microstructures and Mechanical Properties of Bearing Steels Modified for Preparing Nanostructured Bainite

Effect of Si Content on Microstructure and Properties of Low-Carbon Medium-Manganese Steel after Intercritical Heat Treatment

Ultrahigh Ductility, High-Carbon Martensitic Steel

A novel bainitic steel comparable to maraging steel in mechanical properties

Microstructure and mechanical properties of a low carbon carbide-free bainitic steel co-alloyed with Al and Si

Mechanism of Formation and Characteristics of Microstructure of Novel Nanobainitic Steel

Retained Austenite Transformation and Portevin–Le Chatelier Effect in 44CrMn2Si2Mo Steel under Tension

Effect of Intercritical Hardening on Microstructure and Strength and Toughness of Quenched 60si2mn Steel