Abstract:Nanostructured humidity sensors have been facilely prepared by solvent annealing of polystyrene-b-poly(4-vinylpyridine) deposited on interdigitated gold electrodes and subsequent sulphonation. The structure, composition, morphology and hydrophilicity of the block copolymer (BCP) have been characterized by gel-permeation chromatography, H-1 NMR, FT-IR, elemental analysis, scanning electron microscopy and static water contact angle measurements. Phase separation of the BCP film induced by annealing in CHCl3 vapor and hot ethanol resulted in its fishnet-like porous nanostructure. Humidity sensing properties of the nanostructured BCP based sensor have been examined at room temperature, and the sensing mechanism was examined. Both concentration of polymer solution for film preparation, and the sulphonation duration seriously affected the sensing properties of the BCP based sensor. Under optimal conditions, the BCP based sensor demonstrated high response magnitude towards relative humidity (RH) (impedance change of three orders of magnitude in the range of 40-90% RH). Moreover, it was featured with quick response (t(90%) of 10 s and 13 s for humidification and desiccation, respectively), good sensing repeatability and relatively small hysteresis (similar to 5% RH), which is attributed to its special nanostructure. The desirable sensing performance suggests the potentials of the BCP with phase separation-induced nanostructures as high performance humidity sensing material. (C) 2017 Elsevier B.V. All rights reserved.

Novel resistive-type humidity sensor based on poly(p-diethynylbenzene)

A Novel Humidity-Sensitive Material Based On Pdeb With Nickel Complex Catalyst

Humidity sensitive properties and sensing mechanism of π-conjugated polymer p-diethynylbenzene-co-propargyl alcohol

A New Humidity-Sensitive Material Based on PPBT Prepared with Palladium Complex Catalyst

A Novel Humidity Sensor Based on Carbon Black/poly(4-vinylpyridine) Nanocomposite

Humidity sensitive properties of substituted polyacetylenes

A composite of quaternized and crosslinked poly(4-vinylpyridine) with processable polypyrrole for the construction of humidity sensors with improved sensing properties

Surface Acoustic Wave Humidity Sensors Based on Poly(p-Diethynylbenzene) and Sodium Polysulfonesulfonate

Poly(4-vinylpyridine)/carbon Black Composite As a Humidity Sensor

A humidity sensor based on interpenetrating polymer network prepared from poly(dimethylaminoethyl methacrylate) and poly(glycidyl methacrylate)

Bilayer thin film humidity sensors based on sodium polystyrenesulfonate and substituted polyacetylenes

A fast response resistive thin film humidity sensor based on poly(4-vinylpyridine) and poly(glycidyl methacrylate)

Bilayer Composite Humidity Sensor Based on Polyaniline and Polyelectrolyte

Photoluminescence, Electroluminescence, Nonlinear Optical, and Humidity Sensitive Properties of Poly(p-diethynylbenzene) Prepared with a Nickel Acetylide Catalyst

A Novel Resistive Humidity Sensor Based On Sodium Polystyrenesulfonate/Tio2 Nanocomposites

Synthesis and Humidity Sensitive Properties of Pyrrole‐based Polyelectrolytes

Sulphonated Polystyrene-B-poly(4-vinylpyridine) with Nanostructures Induced by Phase Separation As Promising Humidity Sensitive Material

Humidity sensitive properties of a novel soluble conjugated copolymer: ethynylbenzene-co-propargyl alcohol

A RESISTIVE-TYPE NANOSTRUCTURED HUMIDITY SENSOR PREPARED BY ELECTROSPINNING

HUMIDITY SENSITIVE PROPERTIES OF WATER SOLUBLE POLYANILINE

Crosslinked and quaternized poly(4-vinylpyridine)/polypyrrole composite as a potential candidate for the detection of low humidity.