Abstract:The coal-fired boiler combustion process's economic, safety, and environmental performance holds great significance when constructing smart power plants. In coal-fired boiler combustion,H2S and CO are the two main high-temperature corrosive gases. They not only corrode the boiler near the wall surface but also pose severe harm to the atmospheric environment through their exhaust gases. Based on the near-infrared tunable diode laser absorption spectroscopy technology, combined with wavelength modulation spectroscopy and frequency division multiplexing technology, an unstaffed online real-time monitoring instrument for H2S and CO gas concentrations in the main combustion zone of coal-fired boilers was developed. Gas absorption spectroscopy in the 6 335 similar to 6 341 cm(-1) range was simulated, and two near-infrared lasers near 1.5 mu m were selected as the laser source. A high-temperature resistant and corrosion-resistant Herriott-type multi- pass cell was developed to attain an effective optical path length of 15 m for the interaction between laser and gas. Hardware circuits and corresponding firmware programs were developed to attain secondary demodulation of the absorption spectroscopy signals of H2S and CO and concentration inversion. The linearity and Allan variance experiments showed linear fitting correlation coefficients of 0.999 8 and 0.9995. At 73 s and 53 s integration times, the minimum detection limits for H2S and CO were 0.2x10(-6) mol/mol and 0.344x10(-6) mol/mol, respectively. Finally, the developed instrument was applied in the combustion atmosphere of the main combustion zone of a 300 MW tangential four-corner coal-fired boiler, and synchronous measurements of H2S and CO near the water-cooled wall were conducted. The results indicated a positive correlation between the concentrations of H2S and CO in the boiler, with anaerobic combustion leading to an increase in the content of these gases and causing corrosion to the water-cooled wall.

On-line detection of working gases and investigation of discharge instabilities on high power laser

Theoretical Investigation on Exciplex Pumped Alkali Vapor Lasers with Sonic-Level Gas Flow

The influence of tube-plate electrodes on the laser mode of a fast-transvere- flow C02 laser

The Research on Discharge Tube Structure of Fast-Axial-flow CO 2 Lasers

The Influence Of Tube-Plate Electrodes On The Laser Mode Of A Fast-Transverse-Flow Co(2) Laser

Research of Discharge Tube Diameter and Discharge Pressure on Fast-axial-flow CO2 Lasers

Development of an Online Detection Setup for Dissolved Gas in Transformer Insulating Oil

Plasma Behavior and Control with Small Diameter Assisting Gas Nozzle During Co2 Laser Welding

Study on Side Assist Blowing Gas with Different Composition in High Power CO_2 Laser Welding

Stability Information in Plasma Image of High-Power CO2 Laser Welding

Research on Laser Online Monitoring Equipment for High-Temperature Corrosive Gas in Coal-Fired Boilers

Progress of Research of Gas Circulation System in the High Power Fast Axial Flow CO2 Laser

Characteristic Analysis on Laser Induced Plasma of Different Penetration Condition in High Power CO2 Laser Welding

[Study of the Laser Absorption Characteristics of CO(2), Laser-Pulsed GMAW Hybrid Welding Based on Spectral Diagnosis Technique].

Optimization of Discharge Circuit of the Tea Co2 Laser with Two Discharge Channels

Investigation of Plasma and Metal Transfer Dynamic Behavior During Fiber Laser GMAW-P Hybrid Welding

Research on plasma in high power carbon dioxide laser welding of ship plate

Analysis of Kinetics of a Mechanical Q-Switched CO_2 Laser with Longitudinal DC Discharge

Change of Discharge Current in CO2 Plasma Induced by Q-switched CO2 Laser

Planar Laser-Induced Fluorescence Diagnostics for Spatiotemporal OH Evolution in Pulsed Corona Discharge

On-Line Safety Monitoring Of Explosive Gas Concentration For Process In Bf