Abstract:It is common that steam turbine works at different operating points, especially under low load conditions, to cater to complex and varied demands for power generation recently. Considering the long and thin shape of last stage moving blades (LSMBs) in a low-pressure (LP) steam turbine, there are many challenges to design a suitable case which balances global efficiency against sufficient structure strength when suffering excitations at low load operating points. In present work, the aim is to extract specific aerodynamic excitations and recognize their distribution and propagation features. Firstly, steady 3D computational fluid dynamics (CFD) calculations are simulated at 25GV and 17GV (25% and 17% of design mass flow conditions) and corresponding unsteady calculations are performed with enough rotor revolutions to obtain integrated flow periodicities. Unsteady pressure signals near tip region of LSMBs are monitored circumferentially in both static and rotating coordinates. The fast Fourier transformation (FFT) results of unsteady pressure signals show that there are broadband humps with small disturbance amplitudes in low frequency spectrum at 25GV, however, a sharp spike is shown in low frequency spectrum at 17GV. Further, circumferential mode decomposition (CMD) method has been applied to distinguish different fluctuations in frequency and the mode numbers and circumferential propagating pace of which have been obtained. Finally, dynamic mode decomposition (DMD) method has been performed to describe detailed mode shapes of featured flow perturbances both in static and rotating coordinate system. These analyses indicate that at 25GV, a band of unsteady responses with very low amplitude was noted which has some features similar to rotating instability (RI). However, distribution and propagation features of flow unsteadiness at 17GV are in good agreement with rotating stall (RS) in compressor.

CFD applications in steam turbine aerodynamic design

C207 applications of higher-order accurate computational fluid dynamic method to steam turbine blade designs

CFD Calculation and Analysis of Cooling Jacket Flow and Heat Transfer for Car Engine

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

A Cfd Approach to Fluid Dynamic Optimum Design of Steam Turbine Stages with Stator and Rotor Blades

Advances in numerical analysis and design method of turbomachinery and applications in steam turbines part I: Advances in numerical analysis and design method

Application of Computational Fluid Dynamics in Numerical Simulations of Fluid Flow in Complicated Tube-type Components

Development of CFD-based design program for wind tunnel and circulating water channel

A Simplified CFD Method to Partial Admission Fluid Force Estimation in Turbine

Development of an unsteady multi-species numerical method for internal compressible flows in the turbine

Computational Fluid Dynamics Analysis Approach To The Aerodynamic Performance Of A Nozzle Controlling Stage For A 600mw Steam Turbine

Numerical Investigation on Flow Characteristics in Steam Turbine Low Pressure Cylinder and LPEH under Different Volume Flow Rate Conditions

Application of CFD Analysis for Rotating Machinery—Part I: Hydrodynamic, Hydrostatic Bearings and Squeeze Film Damper

Advances in CFD flow simulations for pump-turbine

Aerodynamic Numerical Investigation Of Low-Pressure Steam Turbine Last Stage Under Low Load Conditions With Mode Decomposition Methods

Investigation on Aerodynamic Performance of Controlling Stages for Large Power Steam Turbines

Fluid Dynamic Efficiency Optimization of Steam Turbine Stages Considering Leakage Influences and Inter-stage Reciprocal Interferences

Numerical Simulation Through the Whole Flow Passage of Hydraulic Turbine Based on CFD Technology

Aerodynamics Prediction and Design of A Steam Turbine Exhaust Hood

3-D Steady CFD Analysis of Francis Turbine's Distributor

Feature-based Intelligent System for Steam Simulation Using Computational Fluid Dynamics