Abstract:The sole micropores strictly restrict the wide utilization of TS-1 zeolite in the catalytic fields, especially in the catalytic conversion of compounds with large molecular sizes. Here, we report a feasible and economical method to overcome this drawback. In this work, the hierarchical TS-1 zeolite was constructed via post-acid treatment, post-alkali etching, and a combination of post-acid treatment and alkali etching methods, after which, the corresponding NiMo-supported catalysts were prepared via the incipient wetness impregnation method. Then, the aforementioned materials were fully characterized using X-ray diffraction (XRD), N-2 adsorption-desorption, pyridine adsorbed Fourier transform infrared spectroscopy (Py - FTIR), H-2 temperature programmed reduction (H-2 - TPR), X-ray photoelectron spectroscopy (XPS), and high-resolution transition electron microscope (HR-TEM) to unravel the changes in the physicochemical properties caused by the post treatments. Finally, the hydrodesulfurization of dibenzothiophene (DBT) was used as a probe to assess the effects of the post-treatments on the catalytic performance of the hierarchical NiMo/TS-1 catalysts. The results showed that the MFI topology of TS-1 zeolite remained undamaged significantly and the serial hierarchical TS-1 zeolites exhibited higher specific surface areas and mesopore structures. Moreover, appropriate amounts of Bronsted acid sites were formed at the surface of the serial hierarchical TS-1 zeolites. The interaction between the active metals and the support materials was also modulated by the post-treatment of TS-1 zeolite, which resulted in better dispersion of Ni promoted MoS2 slabs with a higher proportion of NiMoS active phase, further leading to the enhanced catalytic activity and direct desulfurization pathway selectivity of the corresponding serial hierarchical NiMo/TS-1 catalysts. Among all the prepared catalysts, the catalytic activity was enhanced by approximately 1.2 times over catalyst NiMo/AT-TS-1 obtained by post-acid treatment compared to that over catalyst NiMo/TS-1 without treatment and on which the selectivity of the DDS pathway was 22% higher compared to that over catalyst NiMo/TS-1.

EXAFS study on Ni-W hydrotreated catalyst based on US-SSY zeolite

EXAFS studies of influence of Y-type zeolite on hydrotreated catalysts

In Situ Synthesis of Nb-modified AFI Topology Molecular Sieve and Its Modulation on the Formantion of High-Efficiency Catalyst for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

4,6-Dimethyldibenzothiophene Hydrodesulfurization on Nickel-Modified USY-Supported NiMoS Catalysts: Effects of Modification Method

Regulating the Microenvironments and the D-Band Center of Hierarchical Nimos/Ts-1 Catalyst by Zro2 to Enhance the Hydrodesulfurization Performance of Dibenzothiophene

Hierarchical TS-1 zeolite loaded with NiMo catalysts: Preparation and performance in hydrodesulfurization

Effects of Ga- and P-modified USY-based NiMoS catalysts on ultra-deep hydrodesulfurization for FCC diesels

Gallium Modified HUSY Zeolite as an Effective Co-support for NiMo Hydrodesulfurization Catalyst and the Catalyst's High Isomerization Selectivity.

Study on the active phases of Ni-W system hydrotreating catalysts

A High-Resolution MAS NMR Study of the Structure of Fluorinated NiW/γ-Al<sub>2</sub>O<sub>3</sub>Hydrotreating Catalysts

EFFECT OF USY ZEOLITE ON SURFACE STRUCTURE AND ACTIVITY OF HYDROCRACKING CATALYST

A High-Resolution MAS NMR Study of the Structure of Fluorinated NiW/γ-Al2O3 Hydrotreating Catalysts

Study on the hydrodesulfurization active phase in sulfided NiW/Al2O3 catalyst. II. Temperature-programmed reduction

Influence of W on Structure and Hydrodesulfurization Performance of W-Ni2 P/SBA-15 Catalysts

Supported NiW Catalysts with Tunable Size and Morphology of Active Phases for Highly Selective Hydrodesulfurization of Fluid Catalytic Cracking Naphtha

Effect of Zirconium modified Y zeolite via in situ synthesis and its regulation on the formation of excellent NiW catalyst for ultra-deep hydrodesulfurization of 4,6-DMDBT

EXAFS studies on the local structure of Ni and Mo in nickel-molybdenum catalyst system

Study on the hydrodesulfurization active phase in sulfided NiW/Al2O3 catalyst. III. Low-temperature FT-IR spectroscopy of adsorbed CO

Effect of Surface Na+ or K+ Ion Exchange on Hydrodesulfurization Performance of MCM-41-supported Ni–W Catalysts

Experimental and Density Functional Theory Studies on the Zeolite-Based Fe–Ni–W Trimetallic Catalyst for High-Temperature NOx Selective Catalytic Reduction: Identification of Active Sites Suppressing Ammonia Over-oxidation

Solution synthesis of unsupported Ni–W–S hydrotreating catalysts