The structure and surface acidity of zirconia-supported tungsten oxides

Weijie Ji,Jingqiu Hu,Yi Chen
DOI: https://doi.org/10.1023/A:1019041402892
IF: 2.936
1998-01-01
Catalysis Letters
Abstract:The structure and surface acidity of zirconia-supported tungsten oxide are studied by using BET, XRD, FT Raman, Tian–Calvet microcalorimetry as well as XPS. Three different crystal forms of ZrO 2 and their hydroxide precursors were prepared in a controllable way. It was found that the starting material and preparing conditions used have a significant effect on the structure of ZrO 2 obtained. The tungstate species on zirconium hydroxide generally promote the transformation of the hydroxide precursor into tetragonal ZrO 2 , while the same species on the pre-calcined ZrO 2 has less effect during calcination. A bulk-phase WO 3 existed in the samples prepared by initially impregnating the monoclinic, tetragonal and cubic ZrO 2 or the hydroxide precursors of m- and t-ZrO 2 , while no crystalline WO 3 was present in the samples prepared by initially impregnating the hydroxide precursor of c-ZrO 2 . Raman results revealed that the surface tungstate(s) on three different zirconium hydroxides or their respective zirconia have similar structural features before calcination. The surface tungsten oxides and some WO 3 bulk phase are the detectable tungsten species in the final samples, the ratio of each component is strongly dependent on the preparation history and the nature of the support. Creation of very strong acidic sites on the zirconia-supported tungsten oxide is related to the crystal form of zirconia itself, the type of tungsten oxide species, and the cooperation between the surface tungsten oxide overlayer and zirconia. The strong acidic sites can be completely poisoned by the remaining sodium ion impurities, but have not been appreciably influenced by added yttrium component. The crystalline WO 3 seems of little importance in building up the strong surface acidity.
What problem does this paper attempt to address?