Abstract:Deposits, derived primarily from the fuel but with some contribution from the oil are formed inside the combustion chamber of a spark-ignition engine with use. The growth of combustion chamber deposits (CCD) is a dynamic and, to an extent, reversible process which at any given time reflects the balance between the formation and removal processes. Engine surface temperature is the most important parameter that affects their formation and changes in engine operation which tend to increase surface temperature, reduce deposit growth. At a fixed temperature, less volatile fuels tend to form more deposits than more volatile fuels. Some detergent additive packages tend to increase CCD levels. CCD reduce the heat lost to the coolant and increase charge temperature thereby increasing flame propagation rates but reducing volumetric efficiency; they might also affect the final phase of combustion by as yet undefined chemical means. This is reflected as an increase in octane requirement and NOx and a reduction in maximum power but an improvement in fuel economy and a reduction in CO2 emissions. They might also lead to higher HC emissions but not necessarily always since there might be competing mechanisms which come into play. CCD effect on CO emissions is not clearly established. They can also cause other interference problems like carbon rap. It is not known to what extent engine performance is affected by small changes in CCD levels. There is a large variation in deposit growth and its response to changes in fuel, additives and engine operating conditions across the combustion chamber and between different engines. Similarly, the performance of different engines will be affected to different extents by the deposits. While assessing the effects of different fuels or additives on engine performance and emissions through their effects on CCD, the simultaneous effects on other aspects such as inlet valve deposits which might have their own effects on engine operation, should also be considered. The paper reviews the literature on these topics.

Effect of combustion chamber deposits on hydrocarbon emissions in a spark ignition engine

Prediction And Experimental Study On Hydrocarbon Emissions From Combustion Chamber Deposits In A Spark Ignition Engine

A Review of Experimental Studies on Deposits in the Combustion Chambers of Internal Combustion Engines

Combustion Chamber Deposits in Spark-Ignition Engines: A Literature Review

Experimental investigation of the influence of pre-chamber structural parameters on combustion and emission characteristics of a high compression ratio SI engine

Effect of fuel composition on hydrocarbon emissions in spark ignition engine

An Investigation on Simulation Models and Reduction Methods of Unburned Hydrocarbon Emissions in Spark Ignition Engines

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Effect Of Top Land Width And Engine Operating Conditions On Exhaust Hydrocarbon Emissions From A Spark Ignition Engine

Effects of GDI Injector Deposits on Spray and Combustion Characteristics under Different Injection Conditions

Investigation into Hydrocarbon Emissions from Crevice and Oil Film During Cold Start and Idling Periods in A Spark Ignition Engine

Effects of hydrogen enrichment on the combustion and emission characteristics of a turbulent jet ignited medium speed natural gas engine: A numerical study

Impact of Gasoline Engine Deposits on Light Duty Vehicle Emissions: In-Use Case Study in Beijing, China

Effects of Combustion Chamber Necking Sizes on Combustion Process of Diesel Engine

Experimental Study of Combustion Geometry on Combustion and Emissions of Diesel Engine

Effects of passive pre-chamber jet ignition on combustion and emission at gasoline engine

Effect of Key Structure Parameters of Passive Pre-chamber on In-Cylinder Combustion Processes and Emissions within a Gasoline Engine

Effect of Fuel Injection Timings and Hydrogen Fraction on Combustion Characteristics of Direct-Injection Engine

Effect of pre-chamber fuel injection parameters and EGR on the combustion and emissions of a heavy-duty diesel engine

Effect of ignition timing and hydrogen fraction on combustion and emission characteristics of natural gas direct-injection engine

Study on formation process of in-cylinder unburned hydrocarbons during cold start and idling periods in spark ignition engines