Abstract:Hybrid rocket motors have great development potential due to their outstanding thrust adjustment flexibility and long-term operation ability. However, nozzle erosion during the motor operation can cause an increase in the throat area of the nozzle, which leads to a decrease in combustion chamber pressure and nozzle efficiency. Therefore, a performance prediction model for hybrid rocket motors considering nozzle erosion has become a key technology that must be addressed when developing hybrid rocket motors. This study uses dynamic grid technology to simulate the regression of the combustion surface and nozzle erosion, which fits well with experimental values. The behavior of high-energy particles in the combustion chamber is simulated through a discrete phase model. Notably, distinctive behavior is observed in Al and Mg droplets, with Al droplets exhibiting incomplete vaporization in the combustion chamber while Mg droplets completely vaporize. A ground firing test using the Φ336 mm hybrid rocket motor lasting 200 s is conducted. The results show that the dynamic numerical simulation, accounting for nozzle erosion, substantially enhances performance prediction accuracy. The average deviation in motor thrust remains below 1.8%, and the combustion chamber pressure deviation stays under 2.6%, confirming the precision of the model. Ultimately, both simulation and experimental outcomes indicate a gradual decrease in specific impulse and characteristic velocity over the long-term operation, attributed to the gradual deviation of the oxygen-fuel ratio. This research provides valuable insights for guiding hybrid rocket motor design and optimizing design parameters to improve overall performance. This model can achieve long-duration and high-precision performance predictions for hybrid rocket motors.

The analysis of failure of nozzle burned-through in solid rocket motor test

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Numerical investigations of the nozzle performance for a rocket-based rotating detonation engine with film cooling

Preliminary experimental study on combustion characteristics in a solid rocket motor nozzle based on the TDLAS system

Design and analysis of the scramjet nozzle with contact discontinuity

Numerical investigation of surface roughness effects on non-equilibrium flow in expansion section of rocket nozzle

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

New Contour Design Method for Rocket Nozzle of Large Area Ratio

Experimental and numerical investigation on thermochemical erosion and mechanical erosion of carbon-based nozzles in hybrid rocket motors

Modeling and Analysis of Fluid-Solid Coupling Heat Transfer and Fluid Flow in Transonic Nozzle

Cooling Structural Design and Thermodynamic Analysis of Semi-elliptic Nozzle under High Enthalpy and High Heatflux Conditions

Long-Duration Dynamic Numerical Simulation of Combustion and Flow in Hybrid Rocket Motors Considering Nozzle Erosion

Research on flow field characteristics of nozzle plume for a solid rocket motor

Numerical analysis for two-phase flow in dual-thrust chamber with finocyl grain

Failure analysis of the end surface of the burner nozzle made of UMCo50 material in long-term high temperature oxygen-enriched sulfur-chlorine environment

Coupled analysis of the film-cooling and infrared characteristics of an axisymmetric vectoring exhaust nozzle

Burnback Analysis of Solid Propellant Rocket Motors

Computational Analysis and Regression Laws for Nozzle Erosion Prediction in Hybrid Rockets

Performance Analysis of the Scarfed Reversal Nozzle in Solid Rocket Motor

Strength Check for a Solid Rocket Motor Shell based on Integrated Joint Simulation

Design and simulation of a micro thrust solenoid valve nozzle based on CFD&DOE optimization analysis