Abstract:PurposeThe purpose of this paper is to investigate, experimentally and numerically, the pressure pulse characteristics and unsteady flow behavior in a Francis turbine runner for moderate flow heads. The pressure pulses in the runner blade passage were predicted numerically for both moderate and high heads. The calculations were used to partition the turbine operating regions and to clarify the various for the unsteady flow behavior, especially the blade channel vortex in the runner.Design/methodology/approachExperimental and numerical analyses of pressure pulse characteristics at moderate flow heads in a Francis turbine runner were then extended to high heads through numerical modeling with 3D unsteady numerical simulations performed for a number of operating conditions. The unsteady Reynolds‐averaged Navier‐Stokes equations with the k‐ω‐based shear stress transport turbulence model were used to model the unsteady flow within the entire flow passage of a Francis turbine.FindingsThe dominate frequency of the predicted pressure pulses at runner inlet agree with the experimental results in the head cover at moderate flow heads. The influence of the blade passing frequency causes the simulated peak‐to‐peak amplitudes in the runner inlet to be larger than in the head cover. The measured and predicted pressure pulses at different positions along the runner are comparable. At the most unstable operating condition of 0.5a0 guide vane opening, the pressure pulses in the runner blade passage are due to the blade channel vortex and the rotor‐stator interference. The predictions show that the frequency of the blade channel vortex is relatively low and it changes with the operating conditions.Originality/valueThe paper describes a study which experimentally and numerically investigated the pressure pulses characteristics in a Francis turbine runner at moderate flow heads. The pulse characteristics and unsteady flow behavior due to the blade channel vortex in the runner at high heads were investigated numerically, with the turbine operating regions then partitioned to identify safe operating regions.

Quasi-3D design method of rotational flow for Francis runner

Francis runner modification and design for optimum cavitation performance

Study on raising controllability of the turbine runner performance in the process of designing

Blade Shape Approximation for Solving the Bidirectional Flow of Pump-Turbine Runners

Vorticity Analysis of a Francis Turbine Runner

Research on a Full Three-Dimenional Inverse Method for the Mixed-Flow Pump Runner

Study on optimum design of mixed flow turbine runner blade

Research on Francis Turbine Runner with Long and Short Blades Based on CFD

Design Optimization of Axial Flow Hydraulic Turbine Runner: Part I—an Improved Q3D Inverse Method

Flow characteristic analysis under different runner-vane-match

Vorticity Dynamics Analysis of Flow Field in Francis Runner

Numerical Simulation of the Blade Channel Vortices in A Francis Turbine Runner

Advanced design for large hydraulic turbine runner

Three-dimensional Reverse Design Method for Pump-Turbine Runners

Numerical simulation of the runner blade channel vortex in Francis turbine

Numerical Simulation of Unsteady Flows Through A Francis Turbine Runner Using Vortex Methods

Flow in a Francis Turbine with a Three Dimensional Gate Vane

Experimental and Numerical Analysis of Blade Channel Vortices in A Francis Turbine Runner

Analysis of the Internal Flow Behavior on S-shaped Region of a Francis Pump Turbine on Turbine Mode

Three Dimensional Flow Diagnosis of the Pump Turbine Runner Based on the Dynamic Vorticit

Numerical Prediction of Three-Dimensional Turbulent Flow in Turbine Runner Using Algebraic Stress Model