Abstract:A quantitative analysis is made of the phase changes during the phase inversion temperature (PIT) emulsification process of an aqueous hexadecane emulsion stabilized by a tetra-ethylene glycol dodecyl ether surfactant. The mechanical dispersion part of the process takes place at the PIT, at which temperature the emulsion contains three phases: (1) water, with only minute fractions of surfactant and hydrocarbon; (2) an inverse micellar solution, with modest fractions of solubilized water; and (3) a bicontinuous microemulsion, with large concurrent solubilization of both water and hydrocarbon. After the mechanical action at the PIT, the emulsion is immediately cooled to temperatures beneath the PIT range, reducing the number of phases in the emulsion to two, an oil/water (O/W) microemulsion with moderate surfactant and hydrocarbon content, and an inverse micellar hydrocarbon solution with a significantly greater surfactant fraction. The emulsion is characterized by its large fraction of extremely small oil drops, significantly smaller than expected from the mechanical process. These drops are commonly assumed to emanate from the hydrocarbon fraction of the original bicontinuous microemulsion, the small size of the oil drops being a rational consequence of the colloidal dispersion prior to the phase separation. The quantitative analysis of the phase fractions versus temperature revealed this assumption to be premature. The original water phase is not the final aqueous phase in the emulsion; this phase is instead formed from the microemulsion phase by absorbing the original water phase, gradually modifying its own structure to become water-continuous with the originally large hydrocarbon fraction reduced to modest levels. In the process, a part of the original microemulsion is separated, forming the small oil drops.

Determination of Phase Inversion Point in the Emulsification of Polymers

Effect of stirring speed and its change time on phase inversion of high impact polystyrene

Phase inversion during bulk copolymerization of N-phenylmaleimide/styrene in presence of polybutadiene (II): Effects of operation conditions and recipes on occurrence of phase inversion and structure of rubber phase

Preparation of Waterborne Dispersions of Epoxy Resin by the Phase-Inversion Emulsification Technique. 2. Theoretical Consideration of the Phase-Inversion Process

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems.

Rheological behavior of incomplete phase inversion

Rheological Behaviors and Structural Transitions in A Polyethersulfone-Modified Epoxy System During Phase Separation

Polymerization Induced Phase Separation in Poly(ether Imide)-Modified Epoxy Resin Cured with Imidazole

Progress in Phase Inversion Emulsification for Epoxy Resin Waterborne Dispersions

Phase Inversion of Uv-Curable Anionic Polyurethane in the Presence of Acetone Solvent

Phase Inversions Observed in Thermoresponsive Pickering Emulsions Stabilized by Surface Functionalized Colloidal Silica

A new method to judge the phase inversion point of crude emulsion

Polyurethane Anionomers .2. Phase Inversion And Its Effect On Physical-Properties

Modeling of the Phase Inversion Point of Crude Oil Emulsion by Characterization of Crude Oil Physical Properties

Phase inversion simulation of polymer PVDF membrane based on a fluid model

Phase Inversion Temperature (PIT) Emulsification Process

Study on the Origin of Inverted Phase in Drying Solution-Cast Block Copolymer Films

Effect of triblock copolymer surfactant composition on flow-induced phase inversion emulsification in a tapered channel

Mechanistic Investigation on the Formation of Epoxy Resin Multi-Hollow Spheres Prepared by A Phase Inversion Emulsification Technique

Phase inversion and its effect on the properties of polyester polyurethane cationomers

Formation Kinetics of a Polyphthalazine Ether Sulfone Ketone Membrane Via Phase Inversion