Extraction of ofloxacin from water using hydrophobic eutectic solvents
Mahtab Moradi,Ana M. Ferreira,Catarina M.S.S. Neves,Samane Zarei Mahmoudabadi,Gholamreza Pazuki,João A.P. Coutinho
DOI: https://doi.org/10.1016/j.jece.2024.113075
IF: 7.7
2024-05-19
Journal of Environmental Chemical Engineering
Abstract:Wastewater treatment plants do not cope well with emerging micropollutants, such as pharmaceuticals, because they are not effective to remove them. Therefore, this work aims to develop a process for the extraction of ofloxacin (OFX) based on a liquid-liquid extraction using hydrophobic eutectic solvents (HES), coupled with the Conductor-like Screening Model for Real Solvent (COSMO-RS) for solvent screening. First, COSMO-RS was used to predict the partition coefficient of OFX for four HES families: L-menthol: fatty acid, L-menthol: fatty alcohol, fatty acid: fatty acid and fatty acid: fatty alcohols, at three different molar ratios (2:1, 1:1, and 1:2). These results showed that HES formed by fatty acids, especially those with a longer alkyl chain and a higher fatty acid molar ratio, were the most suitable solvents for OFX extraction. Then, the most promising HES to extract OFX was evaluated experimentally. The HES decanoic acid: dodecanoic acid (C10 acid: C12 acid) in a molar ratio of 2:1 being the system with best extraction results of OFX was selected to optimize the extraction conditions of OFX, namely pH, HES: water ratio (v/v), and OFX concentration, using a response surface methodology (RSM). The results obtained showed that at a pH of 5.2, HES-water ratio (v/v) of 1.3, and 2.5 mg/ml of OFX that an extraction efficiency of OFX of (98.8 ± 0.9)% could be achieved. The results show that one-step OFX extraction is possible, but is significantly influenced by both the extraction parameters and the hydrophobic properties of the HES.
engineering, chemical, environmental