Abstract:The detection of explosives has become a critical issue after recent terrorist attacks. This paper describes research on explosives detection using photoneutrons from a photoneutron convertor that consists of 20 kg heavy water in an aluminum container whose shape was optimized to most effectively convert X-rays to photoneutrons. The X-rays were produced by a 9 MeV electron accelerator with an average electron current of 100 mu A, resulted in a photoneutron yield of > 10(11) n/s. Monte-Carlo simulations show that the radiation field is composed of X-ray pulses, fast neutron pulses and thermal neutrons. Both the X-ray and fast neutron pulses are 5 mu s wide with a 300 Hz repetition frequency. The thermal neutron flux, which is higher than 104 n/cm(2)/S, is essentially time invariant. A time shielding circuit was developed for the spectrometry system to halt the sampling process during the intense X-ray pulses. Paraffin, boron carbide and lead were used to protect the detector from interference from the X-rays, fast neutrons, thermal neutrons and background gamma-rays coming from the system materials induced by photoneutrons. 5" x 5" NaI (TI) scintillators were chosen as the detectors to detect the photoneutrons induced gamma-rays from the inspected explosive simulant. Nitrogen (6.01 cps) 10.828 MeV gamma-rays were detected with one detector from a 50 kg carbamide block placed 60 cm in front of the detector. A collimator was used to reduce the number of background 10.828 MeV gamma-rays coming from the nitrogen in the air to improve the signal to background ratio from 0.136 to 1.81. A detector array of seven 5" x 5" NaI (TI) detectors was used to measure the 2-D distributions of N and H in the sample. The combination of photoneutron analysis and X-ray imaging shows promise for enhancing explosives detection capabilities. (c) 2007 Elsevier B.V. All rights reserved.

Concealed explosive detection system based on fast neutron TOF

Explosives detection using photoneutrons produced by X-rays

Direct Detection of Explosives on Solid Surfaces by Mass Spectrometry with an Ambient Ion Source Based on Dielectric Barrier Discharge

Rapid, on-site identification of explosives in nanoliter droplets using a UV reflected fiber optic sensor.

Detection of Trace Explosives Using a Novel Sample Introduction and Ionization Method

Trace Explosive Detection Based on Photonic Crystal Amplified Fluorescence

The C6D6 Detector System on the Back-n Beam Line of CSNS

Explosives Detection Using Dual Energy X-ray Imaging and Photoneutron Analysis

A novel energy resolved neutron imaging detector based on TPX3Cam for the CSNS

Ultrahigh-Sensitivity and Damage-Free Detection of Single Nanometer-Sized Particle

Development of a 256-channel Time-of-flight Electronics System For Neutron Beam Profiling

Non-contact real-time detection of trace nitro-explosives by MOF composites visible-light chemiresistor

Simulations of Scattered Neutrons for the Time-of-flight Enhanced Diagnostics (TOFED) Neutron Spectrometer on EAST

A New Method of Explosive Detection Based on Dual-Energy X-ray Technology and Forward-Scattering

A New Strategy for Selective Detection of Nitrated Explosives Based on A Confinement Effect of Nanocavity

Data Acquisition System with Pulse Height Capability for the Tofed Time-Of-Flight Neutron Spectrometer

Laser Desorption of Explosives from the Surface of Different Real-World Materials Studied Using C2Cl6-Dopant-Assisted Ion Mobility Spectrometry

Fast nuclide identification based on a sequential Bayesian method

Low Background Thermal Neutron Detector System

Systematic Implementation of Spectral CT with a Photon Counting Detector for Liquid Security Inspection

Compact and transportable system for detecting lead-shielded highly enriched uranium using 252Cf rotation method with a water Cherenkov neutron detector