Rapid, on-site identification of explosives in nanoliter droplets using a UV reflected fiber optic sensor.

Xin Li,Qiang Li,Hong Zhou,Hongxia Hao,Tongzhou Wang,Songmin Zhao,Ying Lu,Guoliang Huang
DOI: https://doi.org/10.1016/j.aca.2012.09.022
IF: 6.911
2012-01-01
Analytica Chimica Acta
Abstract:A portable UV (190–400nm) spectrophotometric based reflected fiber optic sensor system is presented for the on-site detection and identification of explosives. A reflected fiber optic sensor for explosives analysis was developed, with low sample consumption (20–100nL) and a wide concentration quantification range (1.1–250mgL−1). Seven common explosives [pentaerythritol tetranitrate (PETN), trinitrophenylmethylnitramine (CE), trinitrotoluene (TNT), dinitrotoluene (DNT), picric acid (PA), cyclotetramethylenetetranitramine (HMX), cyclotrimethylenetrinitramine (RDX)] and a PETN–RDX mixture (to simulate the Semtex used in many terrorist bombings) were quantitatively analyzed and identified by the proposed system in less than 3s per test, with limits of detection (LOD) of 0.3mgL−1. Due to chemical interference problems in the UV wavelengths range, a novel feature matching algorithm (FMA) was proposed for explosive identification, which was proved to have higher specificity and better anti-interference ability. Real post-blast debris samples were analyzed by the proposed method, and the results were validated against an LC/MS/MS method. The rapid, cost-effective detection with low sample consumption and wide applicability achieved by this system is highly suitable for homeland security on-site applications, such as rapid sample screening in post-blast debris.
What problem does this paper attempt to address?