Abstract:An experimental simulation study on the transition from pressurized to boiling operation of a low-temperature, natural circulation nuclear heating reactor (5 MW) developed by INET of Tsinghua University is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instabilities, namely geysering, flashing instability and low-steam quality density wave instability on the transition from pressurized to boiling operation is described. The mechanism of flashing instability, which has never been studied well on this field, is especially interpreted. It is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: (1) increasing of initial pressure by means of a noncondensable gas (N2), which is a very effective method to eliminate geysering and flashing instability at lower pressure. (2) start-up of the reactor at this pressurized condition with a constant heat flux under the limited value of 9 = 0.15 MW ?m-2, which controls the exit temperature of the heated section below the one of net vapor generation, the low steam quality density wave oscillation can be avoided. (3) transition to a lower pressure, boiling operation. The method of transition with low-heat flux and low-inlet subcooling is proposed: at pressurized operation condition, by reducing the heat flux to its lowest level, releasing the noncondensable gas and increasing the heat flux gradually (dq/dt3 kW ?m- 2 ?min-1l) , during which the low-steam quality density wave oscillation can be be prevented from occurring, then the boiling operation condition can be achieved through adjusting the heat flux and inlet subcooling to their designed value. A stable transition from pressurized to boiling operation of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.

Investigation on dynamic character of thermohydraulic test system

Study on dynamic character of thermohydraulic test system of 5MW low temperature nuclear heating reactor

Investigation on Two-Phase Flow Stability in a Natural Circulation System / Untersuchung Der Stabilität Einer Zweiphasenströmung in Einem System Mit Naturumlauf

Experimental analysis on non-thermoequilibrium in a natural circulation system (2. dynamic)

Investigation on two phase flow stability in a natural circulation system with density-neutronics feedback

Study on flow stability margin by method of system identification

Thermalhydraulic Investigation Using a Test Facility Simulating 200 MW Integral Heating Reactor

Numerical and Experimental Investigations of the Static Characteristics of A Natural Circulation System at Nuclear Heating Reactor Conditions

Thermal Hydraulic Modeling of a Natural Circulation Loop

Analysis on Flow Characteristic of Nuclear Heating Reactor

Dynamic response simulation for high temperature gas-cooled reactor with indirect closed brayton cycle

Analysis of Characteristic Curves for Natural Circulation Flow Excursion at Low Steam Quality Conditions

A Study on the Dynamic Characteristics of the Secondary Loop in Nuclear Power Plant

Experimental simulation on transit process of the 5MW nuclear reactor

Experimental and Theoretical Study on Density Wave Instability in Low Quality Natural Circulation Loop

Investigation on thermohydraulic characteristics of novel superheated steam supply system for low temperature nuclear heating reactor

Transient Flow Characteristics Analysis on the Step-Up Process of Control Rod Hydraulic Drive System

Experimental Investigation on Flow Behavior During Start-up of a Heating Reactor

Dynamic model for control system design and simulation of a low temperature nuclear reactor

Experimental and Numerical Investigation of Sub-Cooled Boiling, Condensation, and Void Flashing in Nuclear Heating Reactor Test Loop

Effect of heat flux on the stability of two phase flow natural circulation with low steam quality