Abstract:Laun's rule [H. M. Laun, “Prediction of elastic strains of polymer melts in shear and elongation,” J. Rheol. 30, 459–501 (1986).] is commonly used for evaluating the rate-dependent first normal stress coefficient from the frequency dependence of the complex modulus. We investigate the mathematical conditions underlying the validity of Laun's relationship by employing the time-strain–separable Wagner constitutive formulation to develop an integral expression for the first normal stress coefficient of a complex fluid in steady shear flow. We utilize the fractional Maxwell liquid model to describe the linear relaxation dynamics compactly and accurately and incorporate material nonlinearities using a generalized damping function of Soskey–Winter form. We evaluate this integral representation of the first normal stress coefficient numerically and compare the predictions with Laun's empirical expression. For materials with a broad relaxation spectrum and sufficiently strong strain softening, Laun's relationship enables measurements of linear viscoelastic data to predict the general functional form of the first normal stress coefficient but often with a noticeable quantitative offset. Its predictive power can be enhanced by augmenting the original expression with an adjustable power-law index that is based on the linear viscoelastic characteristics of the specific material being considered. We develop an analytical expression enabling the calculation of the optimal power-law index from the frequency dependence of the viscoelastic spectrum and the strain-softening characteristics of the material. To illustrate this new framework, we analyze published data for an entangled polymer melt and for a semiflexible polymer solution; in both cases our new approach shows significantly improved prediction of the experimentally measured first normal stress coefficient.

Predictions of primary normal stress difference from extrudate swell of rubber compound

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Linear Rheology of Natural Rubber Compounds Filled with Silica, Short Nylon Fiber or Both

Stress level dependent behavior of sand-rubber mixtures

Stress Relaxation Characteristics and Extrudate Swell of the IUPAC-LDPE Melt

Rheological Characterizations and Extrudate Swell Predictions of an LDPE Melt by Two KBKZ-type Constitutive Equations

The Uniaxial Stress–Strain Relationship of Hyperelastic Material Models of Rubber Cracks in the Platens of Papermaking Machines Based on Nonlinear Strain and Stress Measurements with the Finite Element Method

Influence of Proteins and Phospholipids on Strain Softening Behaviors of Natural Rubber

ADVANCES IN THE NUMERICAL INVESTIGATIONS ON EXTRUDATE SWELL OF VISCOELASTIC FLUID

Large Strain Viscoelastic Constitutive Models for Rubber, Part II: Determination of Material Constants

Finite viscoelasticity of filled rubbers: the effects of pre-loading and thermal recovery

Prediction Of Die Swell For A Ldpe Melt By Using Tanner Theory

Excluded Volume Effects on Stress Transmission in Rubber Elasticity

Finite viscoelasticity of filled rubbers: experiments and numerical simulation

Laun's rule for predicting the first normal stress coefficient in complex fluids: A comprehensive investigation using fractional calculus

Prediction of the Contact Behavior of Stepseals: Experimental and Numerical Investigations

A Novel Planar Tension Test of Rubber for Evaluating the Prediction Ability of the Modified Eight-Chain Model under Moderate Finite Deformation

The prediction on the non-linear and time-dependent rheological characteristics

Load-Compression Relationship of Incompressible Circular Rubber Pad Bonded between Rigid Plates

Slight compressibility and sensitivity to changes in Poisson's ratio

Numerical simulation and experimental verification of heat build-up for rubber compounds