Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

Numerical simulation of steam jet submerged in cold water with condensation

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Hydrodynamics and Local Turbulent Mixing of Submerged, Parallel Liquid Jets: Experiments and CFD Simulations

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Numerical investigation on submerged steam jet condensation in subcooled water flow in a restricted channel with the presence of non-condensable gas

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Numerical Modeling and High-Order Scheme for Wet Steam Flow

Study on thermodynamics and flow characteristics of jet condensate in subcooled flowing liquid

Numerical methods development for non-equilibrium wet steam condensing flow

Numerical simulation on the effect of non-condensable gas on direct contact condensation of steam jet in a narrow pipe

Numerical Simulations of Transverse Liquid Jet to a Supersonic Crossflow Using a Pure Two-Fluid Model

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

A NUMERICAL METHOD FOR SPONTANEOUS CONDENSING FLOW AND ITS APPLICATION ON LAVAL NOZZLE

Numerical Simulations of Laminar Film Condensation of H2O/Air or H2O/CO2 on a Vertical Plate

A Practical Numerical Simulation Approach for 3D Wet Steam Flow

Numerical simulation of condensation in microchannels between spherical particles

Numerical Simulation of Spray in Crossflow of Liquid Jet into Air Stream

Numerical investigations on the droplet moving in steam with non-condensable gas by lattice Boltzmann method

Direct Numerical Simulation of Condensing Stratified Flow

Effects of Liquid Film Waviness, Suction, and Fog Formation on Condensation in the Presence of Noncondensable Gases