Abstract:Alvarez-type Drift Tube Linacs (DTLs) are commonly adopted to accelerate the proton or heavy ion beam with the speed range about 0.04 similar to 0.4 times of the light speed in vacuum. Acquisition of appropriate frequency and distribution of the electromagnetic field, and the field stability inside the Alvarez-type DTL cavity are essential to achieve good beam characteristics. The field requirement can be achieved through tuning by tuners and post couplers when the cavity is off-line. The field stability of cavity is usually measured by the tilt sensitivity and the minimum frequency interval between the operation mode and the nearest neighbor mode. The frequency interval will increase with the reduction of the number of the acceleration units (cells) inside the cavity, which is beneficial to fulfill the tilt sensitivity requirement. If the field stability condition is naturally satisfied, the post couplers inside the DTL cavity are not needed, and the cavity frequency and field distribution can be tuned merely by tuners. In this paper, the tuning method based on the pseudo-inverse matrix is applied to the Alvarez-type DTL cavity without post couplers in Xi'an 200 MeV proton application facility (XiPAF). The method is improved by an expanded matrix algorithm and the tuning process is optimized to expedite the iteration during the tuning. The XiPAF DTL cavity has 23 cells and 5 tuners. By adjusting the insertion depths of the tuners, the tuning was achieved in merely one round of iteration. After tuning, the relative error of the peak field distribution and resonant frequency of the cavity reached to within +/- 3% and 325 +/- 0.007 MHz (25 degrees C, vacuum), respectively. It was verified that the field stability meets the requirement from the physical design both before and after tuning.

Terminal voltage-stabilization system of the 4.5MV Van de Graff accelerator at Peking University

Operation and Improvement of 4.5 MV Van De Graaff Accelerator at Peking University

HI-13 Tandem Accelerator Terminal Voltage Modeling Research and Hardware Simulation Platform Design

BEAM PULSING SYSTEM FOR THE4.5 MV ELECTROSTATIC ACCELERATOR AT PEKING UNIVERSITY

Microgan electron cyclotron resonance ion source in a Van de Graaff accelerator terminal

Beam pulsing system for the 4.5MV electrostatic accelerator at Peking Univ

Beam pulsing system for the 4.5 MV electrostatic accelerator

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Using Virtual Synchronous Generator Control Based Energy Storage to Enhance the Stability of Sending Terminal in LCC-HVDC System

Nuclear Material Irradiation System of 4.5 MV Electrostatic Accelerator at Peking University

Fabrication, Tuning, and High-Gradient Testing of an X-band Traveling-Wave Accelerating Structure for VIGAS

Amplitude and Phase Stability Studies in a DC Superconducting Injector

BEAM LOADING TESTS ON DC-SC PHOTOINJECTOR AT PEKING UNIVERSITY*

Tuning and Cold Test of A Four-Vane Rfq with Ramped Inter-Vane Voltage for the Compact Pulsed Hadron Source

BEAM LOADING TESTS ON DC-SC PHOTOINJECTOR AT PEKING UNIVERSITY

RF measurement and tuning for an Alvarez-type drift tube linear accelerator without post couplers

Upgrade of the Extraction System of Permanent Magnet Electron Cyclotron Resonance Ion Source

Optimal design of high-voltage DC power supply of 1.2 MV/45 mA applied to boron neutron capture therapy system

Field tuning and rf measurements of the four-vane radio frequency quadrupole with ramped inter-vane voltage

Field tuning study and RF electromagnetic design of a continuous-wave RFQ with ramped inter-vane voltage for AB-BNCT

Design and Test of an X-band Constant Gradient Structure