Abstract:<p>The injection molding process is widely used for the mass production of plastic parts. However, as product designs become lighter, thinner and smaller, and the allowable tolerances shrink, the need to improve the quality consistency of the injection molding process has emerged as a critical concern. In mass production, injection molding is typically performed using fixed settings of the machine inputs. However, in practice, the properties of the plastic melt invariably change from batch to batch and even from shot to shot. Consequently, the use of fixed parameter settings fails to guarantee the stability of the molded part quality. Existing quality monitoring and control systems for the injection molding process are often based on pressure information. However, obtaining this information generally requires the installation of pressure sensors within the molding cavity, which is not only expensive and time-consuming, but may also interfere with the injection molding process itself. Accordingly, the present study proposes a quality monitoring and control system for injection molding processes based on the tie bar elongation measurements obtained using a strain gage. In the proposed approach, variations in the tie bar strain characteristic are taken to indicate deviations in the process stability and are used to manipulate the processing parameters accordingly in order to ensure the stability and consistency of the molded part quality. The feasibility of the proposed approach is demonstrated by performing injection molding trials with a two-cavity mold designed to produce tensile test specimens. The experimental results show that the quality of the molded parts varies significantly with the injection speed, velocity-to-pressure (V/P) switchover point, holding pressure, and melt temperature. Among these four parameters, the V/P switchover point and holding pressure induce a particularly rapid dynamic response, and thus provide an effective means of compensating for process deviations from shot to shot. By changing the melt temperature to simulate environmental noise, it is shown that the two parameter settings enable the consistency of the part weight to be restored to a range of 0.01 g within six shots. Moreover, the yield rate is enhanced from 60% to 90%.</p>

Analysis on the injection molding of plastic optical-elements

Influences of Model’s Shape on Molding Time in Glass Molding Press

FEM Analysis of Hot-Pressing Process of Aspheric Glass P-SK57 Lens

Research on the multilayer injection molding of thick-walled polymer optical products

Stress analysis of a large diameter aspheric plastic lens in the variable temperature assisted injection molding process

Study of Injection Molding Process to Improve Geometrical Quality of Thick-Walled Polycarbonate Optical Lenses by Reducing Sink Marks

NUMERICAL METHOD OF PACKING ANALYSIS IN INJECTION MOLDING OF POLYMERS

An imaging performance analysis method correlated with geometrical deviation for the injection molded high-precision aspheric negative plastic lens

Analysis of the main factors affecting mass production in the plastic molding process by using the finite element method

Shrinkage and Warpage Mechanism of Overflow Water-Assisted Injection Molding Short Fiber-Reinforced Polymers

Enhancing the quality stability of injection molded parts by adjusting V/P switchover point and holding pressure

Analysis of the Effects on the Quality of Micro Injection Molded Products

Pre-Compensation of Mold in Precision Glass Molding Based on Mathematical Analysis

Quantitative evaluation of refractive index inhomogeneity and its effect on the imaging performance of high-precision injection molded optical lens

Warpage of Injection-Molded Thermoplastics Parts: Numerical Simulation and Experimental Validation

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Prediction of Profile Deviation During Glass Molding of Double-Aspheric Lens

Modeling and Simulation of Injection Molding Process of Polymer Melt by a Robust SPH Method

Optimization of compression molding for double-concave lenses

OPTIMIZATION OF PROCESS PARAMETERS OF INJECTION MOLDING OF OPTICAL ASPHERIC LENS

Prediction of residual stress in precision injection molding of plastic optical lenses based on an improved solidification layer model