Abstract:Good solubility is the premise in solution processing of conjugated polymers while strong z-z interaction in the main chain is generally the main cause for bad dissolution. In this paper, our strategy is introducing the auxiliary solvent and repeat unit with the similar structure as solvent in the main chain for good solubility of conjugated polymer. Based on the well dissolution between the auxiliary solvent and polymer repeat units induce a quasi-single polymer chain and advanced self-assembly, conjugated polymer coils and reversible supramolecular gels were acheived. R-limonene was added into chlorobenzene as the auxiliary solvent for the well solubility of poly(2-(4-(3',7'-dimethyloctylo-xyphenyl)-1,4-pheny-lene-vinylene (P-PPV). Atomic force microscopy (AFM) images of the spin-coated films with solutions of low concentration showed the isolated P-PPV polymer coils and the fine structure inside the coils in chlorobenzene/R-limonene mixture; while with the absence of R-limonene, the packing of sub-polymer chain was clearly observed. In concentrated solution, P-PPV formed a reversible supramolecular gel at the concentration of 2 mg mL(-1) with good temperature response characteristics in chlorobenzene/R-limonene mixture, and the gel temperature of P-PPV is in the range of 55 degrees C to -35 degrees C. Aggregations with different curvatures were obtained in different solvents, which made us further understand the pliability of conjugated polymer. P-PPV molecular chains were dissolved by the enhanced solubility of alkyl sidechain and phenylene ethylene, that made it became pliable and then entangled, which allowed the assembly of polymer coils with high curvature and supramolecular gel with high ratio of solvent wrap. The fluorescence quantum yield and fluorescence lifetime were both improved in conjugated polymer coils and reversible supramolecular gels, but the physical cross-linking points by pi-pi interaction showed low energy level as those of charge trap sites, where the mobility became lower. In the organic light emitting diodes (OLED), the uniform physical cross-linking network made the structure of P-PPV more stable and could effectively improve the stability, brightness, and lifetime of the device.

Effect of organic solvent vapour treatment on spectroscopy of Pr4VOPc dyes in a polymer matrix

Effect of Solvent Vapor on Optical-Properties of Pr(4)Vopc in Polymethylmethacrylate

Vapochromism and Crystallization-Enhanced Emission of 1,1-Disubstituted 2,3,4,5-Tetraphenylsiloles

Absorption spectra of soluble vanadyl phthalocyanine

Enhancing the Solubility of N-Type Diketopyrrolopyrrole-Dicyanovinyl Molecules with Hybrid Siloxane Group for Solution-Processable Organic Field-Effect Transistor

Solvent‐Polarity‐Induced Active Layer Morphology Control in Crystalline Diketopyrrolopyrrole‐Based Low Band Gap Polymer Photovoltaics

Crystallization of PVDF in the PVDF/PMMA blends precipitated from their non-solvents: special “orientation” behavior, morphology, and thermal properties

An Investigation of Solvent Effects on the Optical Properties of Dye Ir-140 Using the Pump Supercontinuum-Probing Technique

Effect and Mechanism of Solvent Properties on Solution Behavior and Films Condensed State Structure for the Semi-rigid Conjugated Polymers

Optical storage performances of spin-coated Pr4MPc/PMMA films

Deep Insights into the Viscosity of Small Molecular Solutions for Organic Light-Emitting Diodes

Printing and in situ Morphology Detection of Organic Thin Film Photovoltaic Devices

Investigation of nanoscale morphological changes in organic photovoltaics during solvent vapor annealing

New Insights on Solvent-Induced Changes in Refractivity and Specific Rotation of Poly(propylene oxide) Systems Extracted from Channeled Spectra

Effect of Different Solvents on the Performance of Organic Light-Emitting Device Based on Red-Fluorescent ACY Dye by Spin Coating Method

Solvent-induced Conjugated Polymer Coils and Reversible Supramolecular Gels in Polyphenylene Ethylene Derivatives

Tailoring the optical properties of dye–polymer composite films based on polyvinyl alcohol doped with phenol red toward flexible optoelectronic applications

New Organic thermally stable materials for optoelectronics devices - A linear spectroscopy study

Effect of Pr6O11 rare-earth oxide on the structural characteristics and optical parameters of polyvinyl alcohol film

Effect of Crystalline Microstructure on the Photophysical Performance of Polymer/Perylene Composite Films

In Situ Analysis of Solvent and Additive Effects on Film Morphology Evolution in Spin‐Cast Small‐Molecule and Polymer Photovoltaic Materials