Abstract:The demand for fiber-filled polymers has witnessed a significant upswing in recent years. A comprehensive understanding of the local fiber orientation is imperative to accurately predict the mechanical properties of fiber-filled products. In this study, we experimentally investigated the fiber orientation kinetics in uniaxial extensional flows. For this, we equipped a rheometer with a Sentmanat extensional measurement device and with an optical train that allows us to measure the fiber orientation in situ during uniaxial extension using small angle light scattering. We investigated an experimental system with glass fibers for the suspended phase (L/D=8−15), and for the matrix either low density polyethylene, which shows strain hardening in extension, or linear low density polyethylene, which shows no strain hardening. For these two polymer matrices, the fiber orientation kinetics were investigated as a function of fiber volume fraction (φ=1%, 5%, and 10%) and Weissenberg number (by varying the Hencky strain rate, ε ̇H=0.01−1s−1). We found that all these parameters did not influence the fiber orientation kinetics in uniaxial extension and that these kinetics can be described by a multiparticle model, based on Jeffery’s equation for single particles. Our results show that, in uniaxial extension, fiber orientation is solely determined by the applied strain and that, up to the concentrated regime (φ≈D/L), fiber-fiber interactions do not influence the fiber orientation. The extensional stress growth coefficient of these composites, which is measured simultaneously with the orientation, shows high agreement with Batchelor’s equation for rodlike suspensions.

New way to measure the orientation distribution of glass fibers in the composite

New Method for Interfacial Evaluation of Carbon Fiber/Thermosetting Composites by Wetting and Electrical Resistance Measurements

Tensile properties of glass fiber reinforced PP composite considering fiber orientations

An Approach for Predicting Fiber Orientation Distribution in Plastic Injection Molding of Composites

Measuring orientation dynamics of carbon fibers by dielectric anisotropy in shear flows

Oriented granulometry to quantify fibre orientation distributions in synthetic and plant fibre composite preforms

Investigations of three-dimensional fiber orientation on mechanical impact behavior of short glass-fiber-reinforced PEEK composites

Effect of fiber orientation on the failure behavior of a glass-fiber reinforced thermoplastic composite

Direct Observation and Measurement of Fiber Architecture in Short Fiber-Polymer Composite Foam Through Micro-Ct Imaging

Elongational Rheology of Glass Fiber-Filled Polymer Composites

Fibre Orientation and Mechanical Properties of Short Glass Fibre Reinforced Pp Composites

Fiber orientation distribution in strain hardening cementitious composites (SHCC): Experimental investigation and consideration of processing effect

Numerical investigation of fiber orientations and homogeneity in powder bed fusion of fiber/polymer composites

Effects of Glass Fiber Surface Condition on the Dielectric Property of Short Glass Fiber Reinforced Pa-6/Pp Composites

Quantitative Fiber Orientation Analysis of Carbon Fiber Sheet Molding Compounds using Polarization Imaging and X-Ray Computed Tomography

In situ experimental investigation of fiber orientation kinetics during uniaxial extensional flow of polymer composites

Mechanical Characterization of Glass/epoxy Polymer Composites Sprayed with Vapor Grown Carbon Nano Fibers

Recent Research Progress of Short Glass Fiber Reinforced Polypropylene

Fibre orientation distribution function mapping for short fibre polymer composite components from low resolution/large volume X-ray computed tomography

Crystallization Behavior and Properties of Glass Fiber Reinforced Polypropylene Composites

Anisotropic Mechanical Response and Strain Localization of a Metallic Glassy-Fiber-Reinforced Polyethylene Terephthalate Fabric