Abstract:In this paper we present a non-associated plane stress anisotropic constitutive model with mixed isotropic-kinematic hardening. The quadratic Hill 1948 and non-quadratic Yld-2000-2d yield criteria [Barlat F, et al. Int J Plasticity 2003;19: 1297–1319.] are considered in the non-associated flow rule (non-AFR) model to account for anisotropic behavior. To predict accurate hardening in cyclic loading conditions, a modification of the hardening model proposed by Chun et al. [Chun BK, et al., Int J Plasticity 2002; 18: 571–595.] is adopted. This one-surface non-linear mixed isotropic-kinematic hardening model does not require loading criterion and can predict Bauschinger effect, transient behavior and permanent softening. The developed model was implemented as a user-defined material subroutine (UMAT) into the commercial finite element code ABAQUS/Standard based on fully implicit backward Euler's method. Cup drawing simulation results for an automotive sheet metal AA5754-O show that the implemented hardening model avoids under- and over-estimation of the cup height respectively generated by kinematic and isotropic hardening laws. Moreover, as will be seen in the results of highly textured AA2090-T3, both cup height and earing profile generated by non-associated flow models are in better agreement with experimental results. Finally, the Yld2004-18p and non-AFR Yld2000-2d models are compared in terms of prediction of directional Lankford coefficients and yield stresses. It is shown that a same order of accuracy that is obtained by Yld2004-18p can be achieved by the non-AFR Yld2000-2d.

Implementation, verification and application of three dimensional HISS model in ABAQUS

Three Dimensional Implementation of HISS Model in ABAQUS

J2-deformation-type Soil Model Coupled with State-Dependent Dilatancy and Fabric Evolution: Multiaxial Formulation and FEM Implementation

Introduction to Partly Soil Models in ABAQUS Software and Their Application to the Geotechnical Engineering

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

FE Realization of a Thermo-Visco-Plastic Constitutive Model Using VUMAT in ABAQUS/Explicit Program

Implicit Integration of an Anisotropic Egg-Shaped Elastoplastic Model for Saturated Soft Clay

Finite Element Modelling of Complex 3D Static and Dynamic Crack Propagation by Embedding Cohesive Elements in Abaqus

Constitutive Model for Large Liquefaction Deformation of Sand and Its Implementation in ABAQUS Software

The implementation of dynamic pore water pressure incremental model in ABAQUS software

Implementation of a staggered algorithm for a phase field model in ABAQUS

User subroutines platform development for rubber hyperelastic constitutive models and its application in finite element analysis

Implementation of arbitrary polyhedral elements for automatic dynamic analyses of three-dimensional structures

Implementation of ABAQUS User Subroutines for Viscoplasticity of 316 Stainless Steel and Zircaloy-4

Evaluation of Anisotropic Constitutive Models: Mixed Anisotropic Hardening and Non-Associated Flow Rule Approach

Abaqus implementation of monolithic and staggered schemes for quasi-static and dynamic fracture phase-field model

Study of Material Constitutive Model for Shear Wall Hysteretic Behavior Analysis

Formulation and implementation of an isotropic plasticity model enriched with shift stress and fractional flow rule

Numerical Implementation of Three-Dimensional Nonlinear Strength Model of Soil and Its Application in Slope Stability Analysis

A three-dimensional constitutive model of High Strength Structural steels

Implementation of the Unified Strength Theory into FEM Codes