Abstract:Beam-based compliant mechanisms have been widely used in many precision applications due to their large-displacement characteristic. Meanwhile, a simple and accurate analytical tool is no doubt useful to assist design and optimize these mechanisms. The pseudo-rigid-body (PRB) model is such a good alternative. The PRB model in a traditional sense, however, is too approximate to calculate some precise characteristics such as center-shift of a flexural joint. In this paper, a new method is proposed to easily establish simple and accurate PRB models for a variety of beam-based compliant mechanisms. As is well known, for most of the beam-based compliant mechanisms, there is usually an instantaneous center of rotation (ICR) on each beam, and the beam can be considered as a fixed-guided beam with one end fixed while the other end moves along a certain curve that usually is an approximate arc around the ICR. In this case, the behavior of beams can be imitated by a rigid bar with two pin-joints. One of the pin-joints is directly added at the end of the rigid bar. The position of the other is determined by the characteristic radius factor, and a torsional spring is added at the position to represent the beam's stiffness. The modeling method is used to analyze two commonly used beam-based compliant mechanisms as examples, i.e. a parallel linear spring stage and a cross strip pivot. The performances of precision, stiffness and stroke for the two mechanisms are investigated, and the method is validated by comparing the results with other research work presented in the literatures. Both cases show the method is intuitive and accurate, and it will be useful in the early phases of the design for beam-based compliant mechanisms.

Pseudo-Rigid-Body Model for Corrugated Cantilever Beam Used in Compliant Mechanisms

Stiffness Analysis of Corrugated Flexure Beam Used in Compliant Mechanisms

A Modified Pseudo-Rigid-body Modeling Approach for Compliant Mechanisms with Fixed-Guided Beam Flexures

An effective pseudo-rigid-body method for beam-based compliant mechanisms

Large-Deflection Analysis of General Beams in Contact-Aided Compliant Mechanisms Using Chained Pseudo-Rigid-Body Model

Modeling and Analysis of Beam Flexure Based Double Parallel Guiding Mechanisms: A Modified Pseudo-Rigid-Body Approach

Modeling Large Spatial Deflections of Slender Beams of Rectangular Cross Sections in Compliant Mechanisms

A comprehensive static modeling methodology via beam theory for compliant mechanisms

Modeling Large Deflections of Initially Curved Beams in Compliant Mechanisms Using Chained Beam Constraint Model

A generalized pseudo-rigid-body PPRR model for both straight and circular beams in compliant mechanisms

Design and analysis of translational joints using corrugated flexural beams with conic curve segments

Exploration of Translational Joint Design Using Corrugated Flexure Units with Bézier Curve Segments

Kinetostatic Modeling and Characterization of Compliant Mechanisms Containing Flexible Beams of Variable Effective Length

Spatial compliance modeling and optimization of a translational joint using corrugated flexure units

Large Deflection of a Compliant Beam with Non-uniform Stiffness Distribution Using a PRB-3R Model.

Stiffness Analysis of Corrugated Flexure Beam Using Stiffness Matrix Method

A Body-frame Beam Constraint Model

Design and Analysis of Translational Joint Using Corrugated Flexure Units with Variable thickness Segments

Design of Flexure Revolute Joint Based on Double Compliant Curved Beam

Design and Modeling of a Curved Beam Compliant Mechanism with Six Degrees of Freedom

A Novel Model To Simulate Flexural Complements In Compliant Sensor Systems