Abstract:Water flow experiments in single tensile and shear granite fractures were conducted to investigate the nonlinear flow behavior. Fracture geometry parameters based on single fracture wall ( R p , Z 2 , Z 3 , Z 4 , JRC ) and two fracture walls (aperture distribution, cluster coefficient) were calculated and compared. The effect of these fracture geometry characteristics on nonlinear flow behavior was explored. Fracture transmissivity, critical Reynolds number, pressure gradient, and normalized transmissivity were analyzed in detail. The result shows that shear fracture geometry has the characteristics of higher mean aperture with higher standard deviation, more clustering contact, and rougher fracture surface. The shear to tensile fracture transmissivity ratio increases from 2.3 to around 370 with the increase of confining pressure from 2 to 60 MPa and the stress-dependence coefficient of shear fractures is close to 1/22 of tensile fractures. The critical pressure gradient increases as confining pressure, indicating that it requires a higher pressure gradient to drive the linear flow to nonlinear flow, namely, when the injection pressure gradient keeps unchanged, high confining pressure causes the nonlinear flow to turn to linear flow. The critical gradient of the shear fracture is 0.004–0.527 MPa/m on average, which is much lower than that of tensile fractures (0.011–26.862 MPa/m), meaning that a lower pressure gradient can drive the linear flow to nonlinear flow in a shear fracture. The average Forchheimer coefficient β for tensile fractures is 0.133, which is about half of the shear fracture (0.253). Regression analysis indicates that a linear relationship exists between β and the fracture geometry parameters (mean aperture η and cluster coefficient ς ) and the correlation coefficient is about 0.925 and 0.920, respectively. Further investigation confirms the "weak inertial effect" with the ( T 0 / T − 1)/ Re data points falling in a straight line before the "strong inertial effect," where the data points fall in an approximately horizontal line.

Nonlinear dynamic analysis of macroscopic fracture of limestone in general experiments

Experimental investigation on macroscopic behavior and microfluidic field of nonlinear flow in rough-walled artificial fracture models

A Cohesive Model-Based Nonlinear Discontinuous Deformation Analysis for Tensile Fracture in Geotechnical Materials

Laboratory Simulation of Flow Through Rough-Walled Microfractures under High Hydraulic Gradient

Fracture Analysis Of Jointed Rock Mass Based On Nonlinear Fem And Physical Experiment

Investigation of Nonlinear Flow Behavior Along a Rough-Walled Limestone Fracture With Acid Dissolution

Fracture analysis of rock mass based on 3-D nonlinear Finite Element Method

Theoretical Study of the Mesoscopic Mechanism of Rock Fractures During Normal Deformation

Study on Macro–Meso Failure Mechanism of Pre-fractured Rock Specimens Under Uniaxial Compression

Numerical simulation of micro crack evolution and failure modes of limestone under uniaxial multi-level cyclic loading

Fracture Analysis of Brittle Materials Based on Nonlinear FEM and Application in Arch Dam with Fractures

Experimental Study on Nonlinear Flow in Granite Tensile and Shear Fractures

Effect of shear-induced contact area and aperture variations on nonlinear flow behaviors in fractal rock fractures

Coupled macro–meso damage constitutive model for fractured rocks based on logistic growth theory

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress

Macro- and Microstructural Characteristics of the Tension–Shear and Compression–Shear Fracture of Granite

Linear fractal evolution characteristics of rock crack distributions during loading process

Mesoscopic Deformation of a Hydraulic and Mechanical Aperture of a Single Fracture under Normal Stress

Numerical Study of Rock Failure due to the Pre-Existing Crack Initiation and Propagation and Hydraulic Fractures Interaction

Experimental Evaluation of Conjugate Flaws on Rock Dynamic Fracturing

Non-dimensionalization and scaling of fracture processes in concrete and rock