Abstract:Adhesives are essential materials in engineering and their strength directly affects the safety of structures. The curing and environmental deterioration are critical areas of focus in adhesive researches. However, conventional studies on adhesive curing emphasize only on the characteristics of the adhesive itself, while studies on deterioration of adhesive-bonded structure tend to concentrate on detecting disbonds. In this work, we proposed to monitor the curing process and thermal failure of adhesive-bonded-structures based on damping measurement using a quantitative electromechanical impedance (Q-EMI) method. The performances of two adhesives, i.e., epoxy and cyanoacrylate, were studied via bonding a piezoelectric transducer onto one end of an alumina bar and measuring the admittance spectrum of the transducer-adhesive-alumina system. Results show that the damping steadily decreases during the curing process and eventually stabilizes for both adhesive-bonded structures. A significantly higher curing rate is observed at 60°C compared to that at room temperature. At high temperatures, the damping will increase dramatically, or no peaks can be observed in the admittance spectrum, indicating adhesive failure. The results indicate that the epoxy adhesive can function normally at temperatures up to 120°C and can endure heating-cooling cycles up to 180°C, while the cyanoacrylate adhesive can function normally at 140°C but fails upon cooling. The proposed Q-EMI method is quite powerful in monitoring the performances of bonded structures.

Bond Mechanics and Failure Mode of Conductive Silver Adhesive for Transducer

Bondline Thickness Effect on Fracture and Cohesive Zone Model of Sintered Nano Silver Adhesive Joints under End Notched Flexure Tests

Loading Rate Response on Shear Mechanical Properties of Conductive Adhesive with Different Silver Contents

Research on the Related Properties of ACF Anisotropic Conductive Adhesive

Bonding adhesive damage study of the secondary cocure reinforcement tensile experiment

Rate-dependent Mechanical Properties of Cured Conductive Adhesives and Drop Impact Behavior of Adhesive Bonding Points in Electronic Interconnection

Adhesively Bonding a Reusable PZT Transducer for Structural Health Monitoring (SHM) with an Ethylene-Acrylic Acid Copolymer Adhesive

Surface Treatment of Micron Silver Flakes with Coupling Agents for High-Performance Electrically Conductive Adhesives

A Phase-field Model of Electrochemical Migration for Silver-based Conductive Adhesives

Effects of coupling agents on the properties of epoxy-based electrically conductive adhesives

Measurement of Adhesive Bonding Strength with an EMAT in the Resonant Mode

Monitoring of the curing process and thermal failure of Adhesive-Bonded Structures based on damping measurement using quantitative electromechanical impedance

Fabrication of silver electrically conductive adhesive to apply in through-hole filling for PCB interconnection

Electrical and Mechanical Reliability and Failure Mechanism Analysis of Electrically Conductive Adhesives

Microstructural Characterization and Mechanical Performance of Wafer-Level SLID Bonded Au-Sn and Cu-Sn Seal Rings for MEMS Encapsulation

Microstructure Regulation and Fabrication of Epoxy-based Conductive Films with Excellent Electrical and Thermal Conductivity, Adhesion, Toughness, and Flexibility

Fracture Study of Ultrasonic Aluminum Wire Wedge Bonding on Copper Substrate with Mechanical Peeling-Off Method

High Strain Survivability of Piezoceramics by Optimal Bonding Adhesive Design

Tensile Failure Behaviors of Adhesively Bonded Structure Based on In Situ X-ray CT and FEA

Long-time Reliable Direct Bonding of Silver Flake Paste on Al Substrate for Power Electronic Die-Attachment

Effect of Flake Silver-Plated Copper Particles on the Property Enhancement of Electrically Conductive Adhesives.