Abstract:Sweeping Jet Actuator (SJA) was introduced as a potential active flow control method for reducing three-dimension (3D) flow separations in a compressor cascade. Unlike some other actuators, SJA needs no valves or moving parts to convert its steady compressed air source into sweeping jets that oscillates from side to side through the millimeter-sized outlet nozzle. The rather simple and small structure makes it possible to place SJA into the blades. In this study, a 3D numerical simulation using unsteady RANS codes was conducted to investigate the effects of SJA on the flow pattern and the aerodynamic loss mechanism in a compressor cascade. Firstly, the reliability of a commercial Computational Fluid Dynamic (CFD) code was validated and the computed results showed good agreements with experimental data from the literature. Secondly, some possible affecting factors, such as actuating pressure, position of SJA exit and jet skew angle, were analyzed and discussed in detail. Moreover, the effectiveness of active flow control under different locations and stream directions of SJA was studied for obtaining a further understanding of the mechanism of SJA for controlling flow separations. In addition, the generation and interaction of internal secondary flows in the compressor cascade were also investigated, and the oscillating jet process of SJA was presented. The numerical results indicate that using SJA delays effectively the corner flow separation, thus decreases the aerodynamic loss of the compressor cascade. For the optimum scheme within the present research, the reduction of overall time-averaged total pressure loss coefficient achieves about 5.6% compared with the original case without SJA. The streamwise position of SJA has a more remarkable influence in improving performance than the other SJA schemes. The considerable improvements of flow separation in the corner region is considered to be one of the main reasons in overall performance increase.

Numerical simulation of synthetic jet actuator and its controlling effect on the S-inlet

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical Investigation on Synthetic Jet Flow Control Inside an S-inlet Duct

Numerical study of the effectiveness of using a single micro-jet actuator to vector primary flow

Numerical simulation of flow fields of synthetic jet and across primary jet

Characteristics of a Synthetic Jet Actuator and Its Application on Control of Flow over a Backward Facing Step

Numerical simulation investigation on the suction stroke and blowing stroke of synthetic jet circulation control

Analysis Of Synthetic Jet Piv Experiment Based On Dynamic Mode Decomposition

Numerical Simulation of Synthetic Jet Flow Field and Parameter Analysis of Actuator

Numerical Simulation Investigation on Parameters Influencing Synthetic-Jet for Active Flow Control

Numerical simulation of mixing control for coaxial jets with synthetic jet

Influence of Active Flow Control of Synthetic Jet at Suction Surface on the Performance of a Subsonic Axial Compressor Rotor

Design of high-power synthetic jet actuator and its flowfield investigation

Numerical Simulation of Active Flow Control to Airfoil Stall Using Local Synthetic Jet

3D Numerical Simulation of Compressible Gas Synthetic Jet

Numerical Simulation of Active Stall Control on High-lift Airfoil

Effects of Actuation Parameters on Flow Separation Control in Compressor with Synthetic Jets

Improving 3D Synthetic Jet Modeling in a Crossflow

Numerical Investigation of a Sweeping Jet Actuator for Active Flow Control in a Compressor Cascade

Numerical Investigation of Efficient Synthetic Jets Generated by Multiple-Frequency Actuating Signals

A 2d Simulation of the Flow Separation Control over A Naca0015 Airfoil Using A Synthetic Jet Actuator