Abstract:The vacuum degree of vacuum interrupter, the isolation contact and the surface insulation condition, when in bad status, are all possible causes of serious insulation or current carry failures to high voltage vacuum cubicle switchboard. A large series of experiments have been executed in this paper to verify the feasibility of using Ratio Frequency (RF) signal emitted by the partial discharge under those situations to online monitor the condition of high voltage vacuum cabinet. Firstly, A floating electrode gap was adopted and its discharge characteristic under different vacuum degree (6.7x10(-3)similar to 1x10(5)Pa) has been studied. The experiment results indicated that when vacuum degree descend to some extent, partial discharge will occur in the gap. Furthermore, the start voltage and the characteristics of the discharge have direct relations to vacuum degree. The discharging or not of such a gap fixed in the vacuum interrupter can indicate whether the vacuum degree is in normal range. Secondly, a series of experiments on bad contact and surface insulation have been carried out, and it has been proved by the experiments that the intensity of the RF signal (above 10mV) can show the development and situation of the isolation contact and surface insulation failure. While high gain like 60dB was needed to the antenna. Since the intensity of the signal acquired was strongly affected by the position of the sensor and the case of shielding, locating the failure and identifying the disturbance from outside of the cubicle switchboard can be realized.

Development of an On-Line Monitoring System of Vacuum Degree in 35kv Vacuum Tube

Development of an On-line Monitoring System of Vacuum Pressure in 35 kV Vacuum Interrupter

Condition Monitoring System of Simulator Test Rig for Shield Tunnelling Machine

The development of online monitor system of vacuum circuit breaker's electrical endurance

Development of on-line monitoring system for insulation of high voltage electrical equipment

Hardware Design of Online Monitoring Device for the High-voltage Vacuum Circuit Breaker

Development of an On-line Monitoring System of 1.5 Kv DC Cable

On-line Monitoring Method for Mechanical Characteristics of Vacuum Circuit Breakers

On-line Monitoring System for Leakage Current of Exterior Insulation in Power Substation Based on Technology of Virtual Instrument

Development of On-line Monitoring System of Medium Voltage Switchgear

Air Pump Unit Online State Monitoring System

Life Monitoring and Assessment System of High Temperature Tube Based on the Web Technology

Development of an On-Line Monitoring System for a Large-Scale Reciprocating Hydrogen Compressor Group Based on LabVIEW

On-line Over-Voltage Monitoring System Based on Virtual Instrument

Study on the Change Tendency of Electro-Magnetic Signal under Different Vacuum Degree for 10kv Vacuum Chamber

Development of an Overall Condition Monitoring System of High Voltage SF 6 Circuit Breaker

Study on On-line Monitoring of Valves leakage

Utilizing Ratio Frequency signal in online monitoring on high voltage vacuum cubicle switchboard

Vacuum Monitoring System of HLS Storage Ring

Development of contamination leakage current online monitoring system for substations

Experimental Study of Vacuum Degree Online Detection of Vacuum Interrupter Based on Laser Induced Breakdown Spectroscopy