Abstract:The transition mechanism is of significance to the corrosion behavior of zirconium alloys. Two important phenomena may be the causes of transition, which are the undulated wavy interface and the existence of tetragonal zirconia at the metal/oxide interface. There is little detailed study on the correlation between these two features. Micro-scale Raman imaging of intensity and Raman shifts was conducted in this study to further evaluate the connection. It was studied based on the oxide films formed on Zr-0.5Sn-0.15Nb-0.5Fe-0.2 V and N36 claddings corroded in 500 degrees C/10.3 MPa steam. The stress in interfacial tetragonal zirconia has relationship with the amplitude to wavelength ratio of the undulated part and it is always found to be larger at the convex parts of interface. These parts are prone to crack formation. At one convex position that the oxide cracked, t-ZrO2 is found to be preserved beneath and above the crack. Stress is also preserved, but partially released. When interfacial t-ZrO2 exists, the stress in the surrounding monoclinic phase is observed to be small. This provides us a more detailed figure of the stress distribution in oxide film. Tetragonal phase is mainly distributed near the metal/oxide interface. More intense tetragonal signals are frequently found at the convex positions of interface. This might result from large tetragonal grains or aggregation of small t-ZrO2 grains. These grains are stabilized at convex parts because of the large compressive stress and might be unstable once the grain size exceeds a critical value or once cracks are formed at such positions. An illustration of the connection between t-ZrO2 and undulated interface is then proposed. Possible reasons that facilitate the formation of lateral cracks and possible reasons for the existence of t-ZrO2 at the convex positions are discussed. (C) 2019 Elsevier B.V. All rights reserved.

In Situ Measurement of Stresses and Phase Compositions of the Zirconia Scale During Oxidation of Zirconium by Raman Spectroscopy

Comparison of Raman imaging assessment methods in phase determination and stress analysis of zirconium oxide layer

Mechanical–chemical coupling phase-field modeling for inhomogeneous oxidation of zirconium induced by stress–oxidation interaction

Rapid assessment of structural and compositional changes during early stages of zirconium alloy oxidation

Quantification of Yttria in Stabilized Zirconia by Raman Spectroscopy

Research on the Existence and Stability of Interfacial Tetragonal Zirconia Formed on Zirconium Alloys

Self-toughening mechanism of the ZrO2 scale and the precipitation of Sn during the steam oxidation of ZIRLO™ at 1200 °C

Self-toughening mechanism of the ZrO 2 scale and the precipitation of Sn during the steam oxidation of ZIRLO TM at 1200°C

Unveiling the feature of deposition of oxygen and water molecules on the zirconium surface: A molecular dynamic study

A quantitative microscopic view on the gas‐phase‐dependent phase transformation from tetragonal to monoclinic ZrO2

On solid solution hardening in the zirconium-oxygen system

Exploring the stability, thermodynamic and mechanical properties of zirconium oxides and suboxides under temperature and pressure: A first-principles predictions

The Correlation Between Tetragonal Phase and the Undulated Metal/oxide Interface in the Oxide Films of Zirconium Alloys

Oxygen vacancy mediated cubic phase stabilization at room temperature in pure nano-crystalline Zirconia films: A combined experimental and first-principles based investigation

Correlation between oxygen-related defects and lattice strain in tetragonal phase stabilized doped-zirconia systems

Enhanced plasticity of the oxide scales by in-situ formed Cr2O3/Cr heterostructures for Cr-based coatings on Zr alloy in 1200 °C steam

The air oxidation of yttrium ion implanted zircaloy-4 at 500°C

Vibrational Spectroscopy of Dispersed Re VII O x Sites Supported on Monoclinic Zirconia

Oxygen vacancy stabilized zirconia (OVSZ); a joint experimental and theoretical study

Influence of Oxidation Time on Microstructure and Composition of Micro-Arc Oxidation Coatings Formed on Zirconium

Effects of Roughness on Stresses in an Oxide Scale Formed on a Superalloy Substrate