Abstract:Time-varying sliding friction force and friction torque are regarded as non-negligible excitation sources of vibration and noise in gears. The sliding friction force primarily excites the motion along the off-line-of-action direction, which transmits vibration to the housing through shafts and bearings and then radiates noise. Since the contact line intersects with the pitch line, and the directions of the friction forces are opposite on both sides of the pitch line, the calculation of the friction excitations in helical gears becomes more difficult, especially in the high contact ratio helical gears. However, there is no universal method for calculating the friction excitations in helical gears with different range of contact ratio. The changes of friction excitations in helical gears are highly dependent on the geometric parameters such as helix angle and face width among others. Yet, there exist very limited studies on these topics. In this study, a refined general formulation for the calculation of time-varying contact line and friction excitations is proposed by assuming uniform load distribution along the contact lines with time-varying normal force and friction coefficient. Key gear parameters such as modification coefficient, helix angle, and face width are analyzed to illustrate their effects on the time-varying contact line and friction excitations. The results demonstrate that the refined general formulation is effective for the calculation of the friction excitations in helical gears with different range of contact ratio, and the parametric analysis could supply some guidance for choosing gear parameters in the design of helical gears to reduce the friction excitations.

Dynamic characteristics of helical gears under sliding friction with spalling defect

Dynamic Analysis of Helical Gears with Sliding Friction and Gear Errors

Nonlinear Dynamics and Meshing State Transition Analysis of Spalling Defect Gears with Multi-Lubrication Conditions

Meshing and dynamic characteristics analysis of spalled gear systems: A theoretical and experimental study

Investigation on the Influence of Spalling Defects on the Dynamic Performance of Planetary Gear Sets with Sliding Friction

The Influence of Mesh Misalignment on the Dynamic Characteristics of Helical Gears Including Sliding Friction

Dynamic Features of Three-Dimensional Helical Gears under Sliding Friction with Tooth Breakage

Dynamic Characteristics of Helical Gears Incorporating the Effects of Coupled Sliding Friction

Dynamic Modeling and Analysis of Spur Gears Considering Friction–vibration Interactions

Fault Feature Analysis of Gear Tooth Spalling Based on Dynamic Simulation and Experiments

Vibration characteristics analysis of flexible helical gear system with multi-tooth spalling fault: Simulation and experimental study

Dynamic Modeling of Gear System Based on 3D Finite Element Model and Its Application in Spalling Fault Analysis

Dynamic Behavior Analysis of Spur Gears with Constant & Variable Excitations Considering Sliding Friction Influence

Analysis of Time-Varying Friction Excitations in Helical Gears with Refined General Formulation

Excitation Prediction by Dynamic Transmission Error under Sliding Friction in Helical Gear System

Mesh characteristic analysis and dynamic simulation of spur gear pair considering corner contact and tooth broken fault

Time-varying mesh stiffness calculation of a planetary gear set with the spalling defect under sliding friction

Time-varying Mesh Stiffness Calculation and Dynamic Modeling of Spiral Bevel Gear with Spalling Defects

Deformation and Response Analysis of Spur Gear Pairs with Flexible Ring Gears and Localized Spalling Faults

Dynamic response analysis of helical gear pair considering the interaction between friction and mesh stiffness

Analytical models of mesh stiffness for cracked spur gears considering gear body deflection and dynamic simulation