Abstract:Titanium alloys are widely used in aviation, marine, automotive, offshore, and medical fields. However, their poor wear resistance reduces the safety and reliability of components during service. Few study has been previously conducted on the wear resistance enhancement of titanium alloys (including Ti–6Al–4V alloy) processed by mechanical cutting. High-speed ultrasonic vibration cutting (HUVC) is an effective approach for improving the machinability of titanium alloys. In this study, we attempted to utilize HUVC improving the wear resistance of titanium alloys. After conducting high-speed turning (cutting speed within the range of 200–300 m/min), the surface integrities (surface roughness, microstructure, in-depth micro-hardness, and residual stress) of conventional cutting (CC)- and HUVC-machined samples were characterized. Experimental results demonstrated that, compared with CC, HUVC achieved a thicker plastic deformation layer (greater than 46.93 μm), lower surface roughness, higher surface micro-hardness (greater than 433 HV 0.05 ), and higher compressive residual stress (up to −840 MPa). Moreover, surface nanocrystallization and gradient nanostructured layer were observed in HUVC-machined Ti–6Al–4V samples. In addition, compared with CC, HUVC effectively further reduced the friction coefficient and worn volume loss (decreased by 20.98%–25.59%) and ultimately improved the wear resistance. The hardness has a higher influence on the wear resistance of the machined Ti–6Al–4V alloy than the other surface integrity factors. Therefore, the proposed mechanical cutting operation was confirmed to improve the wear resistance of titanium alloys.

Experimental Study on the Wear of Diamond Tools in Precision Cutting of Titanium Alloy

Influence of Tool Geometrical Parameters on High Speed Cutting of Titanium Alloy Ti6Al4V

Wear Behaviors of Pcd Tools in Turning Granite

Performance and wear mechanisms of PCD and pcBN cutting tools during machining titanium alloy Ti6Al4V

Wear mechanism of diamond-cutting tool in nano-cutting polycrystalline γ-TiAl alloy based on molecular dynamics simulation

Inlfuences of Material Tool and Tool Wear on Cutting Temperature of Turning Titanium Matrix Composites

Study on tool wear mechanism of single-crystal diamond in ultrasonic vibration elliptical cutting of tungsten heavy alloy

An Investigation of Cutting Performance and Action Mechanism in Ultrasonic Vibration-Assisted Milling of Ti6Al4V Using a PCD Tool

Study on Cutting Processing Technology of Titanium Alloy

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Analysis of tool wear of TiAlN coated tool, machined surface morphology and chip during titanium alloy milling

Enhancing Tool Performance in High-Speed End Milling of Ti-6Al-4V Alloy: The Role of AlCrN PVD Coatings and Resistance to Chipping Wear

Inhibitory Effect of Laser Surface Texturing in Dry Cutting of Titanium Alloy on Cemented Carbide Tool Wear

Finite element analysis of Ti 1-x Al x N coated tools cutting performance and tool wear during Ti-6Al-4V milling

Tool Wear in Ultra-Precision Diamond Cutting of Non-Ferrous Metals with a Round-Nose Tool

Surface integrity evolution and wear evolution of the micro-blasted coated tool in high-speed turning of Ti6Al4V

Effect of high-speed ultrasonic vibration cutting on the microstructure, surface integrity, and wear behavior of titanium alloy

Influence of Cutting Conditions on the Wear Resistance of Tools with a TiB2 Coating during Titanium Alloy Machining

Mass production and cutting performance of diamond coated cutting tools for machining titanium alloys

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

An Investigation of the Effect of Novel Mono/Bi-Layered PVD-Coated WC Tools on the Machinability of Ti-5Al-5V-5Mo-3Cr