Abstract:A fully inkjet-printed strain sensor based on carbon nanotubes (CNTs) was fabricated in this study for microstrain and microcrack detection. Carbon nanotubes and silver films were used as the sensing layer and conductive layer, respectively. Inkjet-printed CNTs easily undergo agglomeration due to van der Waals forces between CNTs, resulting in uneven films. The uniformity of CNT film affects the electrical and mechanical properties. Multi-pass printing and pattern rotation provided precise quantities of sensing materials, enabling the realization of uniform CNT films and stable resistance. Three strain sensors printed eight-layer CNT film by unidirectional printing, rotated by 180° and 90° were compared. The low density on one side of eight-layer CNT film by unidirectional printing results in more disconnection and poor connectivity with the silver film, thereby, significantly increasing the resistance. For 180° rotation eight-layer strain sensors, lower sensitivity and smaller measured range were found because strain was applied to the uneven CNT film resulting in non-uniform strain distribution. Lower resistance and better strain sensitivity was obtained for eight-layer strain sensor with 90° rotation because of uniform film. Given the uniform surface morphology and saturated sheet resistance of the 20-layer CNT film, the strain performance of the 20-layer CNT strain sensor was also examined. Excluding the permanent destruction of the first strain, 0.76% and 1.05% responses were obtained for the 8- and 20-layer strain sensors under strain between 0% and 3128 με, respectively, which demonstrates the high reproducibility and recoverability of the sensor. The gauge factor (GF) of 20-layer strain sensor was found to be 2.77 under strain from 71 to 3128 με, which is higher than eight-layer strain sensor (GF = 1.93) due to the uniform surface morphology and stable resistance. The strain sensors exhibited a highly linear and reversible behavior under strain of 71 to 3128 με, so that the microstrain level could be clearly distinguished. The technology of the fully inkjet-printed CNT-based microstrain sensor provides high reproducibility, stability, and rapid hardness detection.

Strain Sensor of Carbon Nanotubes in Microscale: from Model to Metrology

The Use of A Carbon Nanotube Sensor for Measuring Strain by Micro-Raman Spectroscopy

Study on the CNT sensor for strain measurement and its control method of Raman polarization

A New Theoretical Model of A Carbon Nanotube Strain Sensor

Recent Advances in Flexible Pressure/strain Sensors Using Carbon Nanotubes

Performance Analysis of Carbon Nanotube Strain Sensor:Influence Mechanism of Polarization Mode

Experimental Study of the Raman Strain Rosette Based on the Carbon Nanotube Strain Sensor

Carbon Nanotube‐Based Strain Sensors: Structures, Fabrication, and Applications

Sensitivity-Tunable Strain Sensors Based on Carbon Nanotube@Carbon Nanocoil Hybrid Networks.

Strain Sensing of Carbon Nanotubes: Numerical Analysis of the Vibrational Frequency of Deformed Single-Wall Carbon Nanotubes

Linear Strain Sensor Made of Multi-Walled Carbon Nanotube/epoxy Composite

Investigation of strain sensing mechanisms on the ultra-thin carbon nanotube networks with different densities

Structure and Function Design of Carbon Nanotube-Based Flexible Strain Sensors and Their Application

Carbon nanotube thin film strain sensors: comparison between experimental tests and numerical simulations

A carbon nanotube strain sensor for structural health monitoring

Multi-Walled Carbon Nanotubes-Based Sensors for Strain Sensing Applications

Carbon Nanotube Yarn Strain Sensors

Development Of Flexible Carbon Nanotube-Polymer Hybrid Thin Film For Strain Sensing

Superior Piezoresistive Strain Sensing Behaviors of Carbon Nanotubes in One-Dimensional Polymer Fiber Structure

A Fully Inkjet-Printed Strain Sensor Based on Carbon Nanotubes

Comparative analysis for strain response and life monitoring of composite using carbon-based nanosensors