The vertical distribution of PM2.5 and boundary-layer structure during winter haze in Nanjing
Jun Zou,Jianning Sun,Zixuan Xiang,Xiaomen Han,Qiuji Ding
DOI: https://doi.org/10.5194/egusphere-egu2020-2198
2020-01-01
Abstract:<p>At the end of November 2018, a heavy air pollution event was recorded by many meteorological stations in the Yangtze River Delta (YRD), China. The local PM2.5 concentration exceeding to 200 &#181;g m<sup>-3</sup>. This is the heaviest, longest and most widespread heavy-polluted weather in Jiangsu Province since 2018. Meanwhile, there has been severe foggy weather in Jiangsu Province, with visibility less than 200 meters in most parts of the province. In order to study the interaction between PM2.5 concentration and boundary layer height in the haze event, and the effect of fog on pollutant aggregation, the boundary layer structure of the continuous haze process was analyzed by using the SORPES Observation of Nanjing University's Xianlin Campus. The results of the analysis show that:<br>1, The PM2.5 concentration in the boundary layer is inversely correlated with the boundary layer height, the higher the PM2.5 concentration, the lower the boundary layer height during the day. By absorbing and scattering solar radiation, atmospheric aerosols affect the balance of surface energy and reduce the sensitive heat flux, thereby inhibiting the development of the boundary layer. While inhibited development of the boundary layer will limit the diffusion of atmospheric aerosols, thereby increasing the concentration of atmospheric aerosols in the boundary layer. In addition, nocturnal atmospheric aerosols absorb heat, leading to strong grounding inversion temperature the next day, further inhibiting the development of the daytime boundary layer.&#160;<br>2, The fog-top inversion is very strong, far stronger than the inversion caused by atmospheric aerosols. Therefore, the heights of the boundary layer of fog days are much lower than that of non-fog days under the same pollution conditions.<br>3, During the fog, the PM2.5 concentration significantly reduced. And after the fog dissipated, due to the sun, the air moisture evaporation, PM2.5 concentration quickly reverted to the pre-fog state. Fog has limited wet removal of PM2.5.<br>4, Fog can inhibit the development of the boundary layer, with the continuation of the fog process, the pollution in the boundary layer continues to increase. At the same time, due to the inhibition of the development of the boundary layer, the diffusion of water vapor in the air is also affected, resulting in the boundary layer water vapor content is always in a high state, thus promoting the production of fog.</p>