Abstract:Harmful algal blooms(HABs),commonly known as red tide; it occurred frequently in recent years in many coastal waters,which has caused serious environmental problems with its toxin to aquiculture.To effectively put off the HAB damage,scientists have tried many different countermeasures to remedy the environment; spreading clay was therefore considered as one of the measures.In this paper,two types of clays,kaolinite and bentonite,were tested to remove a red tide organism-Heterosigma akashiwo,a major HAB member in China's coastal waters.However,application of natural clays did not produce a satisfactory result,as the coagulation rate was very slow.In order to enhance the capability of remediation,the clays were processed with a new type of surfactant-dialkyl-polyoxyethe-nyl-quaternary ammonium compound(DPQAC). Before application,the removal rate of the organo-clays was examined.The DPQAC-treated clays showed excellent performance against the red tide organisms(in concentration of 5×104-1×105cell/ml),reaching nearly 100% of killing in 24 hours with clay concentration of 0.03g/L(in which the DPQAC concentration was 3mg/L),while the same concentration of untreated clay did not have such high capability under the same condition. The kinetics of red tide organism coagulation with clays was also studied.The effects of different concentrations of the treated and untreated clays,and various pH values of culture medium on the coagulation rate were examined.The results showed that the algae coagulation rate of kaolinite was faster than that of bentonite; and increasing clay concentration could accelerate the coagulation,but adding DPQAC in clays could considerably improve the algal removal efficiency. Moreover,the toxicity of DPQAC and the influence of organo-clays on mariculture animals were tested.Shrimp Penaeus japonicus was chosen to be the animal.The results showed that the toxicity of DPQAC was 50 times lower than traditionally used hexadecyltrimethyleamine bromide; the LC_ 50 concentration(lethal to 50% of test organisms) was about 61.9mg/L.Combined with clays,the DPQAC toxicity were decreased obviously.The application of DPQAC-treated clays could not only increase algal removal efficiency but also decrease the toxicity of the surfactant in aquiculture. Adding DPQAC to the clays was proved to be an effective countermeasure for remedying HAB,which provides an alternative in real case application in future for enhancing greatly the performance of HAB prevention in aquiculture.

Harmful Algae Blooms Removal from Fresh Water with Modified Vermiculite

Removal of Chattonella marina with clay minerals modified with a gemini surfactant

Flocculation Removal of Microcystis Aeruginosa by Chitosan-Bentonite Compound Material

Removal of cyanobacterial blooms in Taihu Lake using local soils II. Effective removal of Microcystis aeruginosa using local soils and sediments modified by chitosan

Effect of hydrodynamic condition on algae control based on montmorillonite modified lime-ceramic sand-lake sediments

Removal of Low Concentrations of Ammonium and Humic Acid from Simulated Groundwater by Vermiculite/Palygorskite Mixture.

Removal of Algal Blooms in Freshwater by Meso-porous Composite Coagulant

Simultaneous Removal Of Harmful Algal Blooms And Microcystins Using Microorganism- And Chitosan-Modified Local Soil

Removal of Harmful Alga, Chattonella Marina, by Recyclable Natural Magnetic Sphalerite.

Thermodynamic and kinetic studies on harmful algal blooms harvesting by novel etherified cationic straw flocculant

Removal Effects and Mechanisms of Microcystic Aeruginosa by Chitosan-Modified Adsorbent

Using flocculation and subsequent biomanipulation to control microcystis blooms: A laboratory study

A novel magnetic buoyant-bead flotation method for the removal of typical microalgae from harmful algal blooms

Removal of Microcystis aeruginosa and microcystin-LR using chitosan (CTS)-modified cellulose fibers and ferric chloride

REMEDIATION FROM HARMFUL ALGAE BLOOM WITH ORGANO-CLAY PROCESSED SURFACTANT

Efficient Elimination and Re-Growth Inhibition of Harmful Bloom-Forming Cyanobacteria Using Surface-Functionalized Microbubbles

Application of PAC-modified kaolin to mitigate Prorocentrum donghaiense: effects on cell removal and phosphorus cycling in a laboratory setting

Removal of harmful algal blooms using activated fly ash-modified chitosan

Simultaneous removing algal and its extracellular organic matters by Mg/Al-layered double hydroxide /La-montmorillonite

Removal of Algal Blooms from Freshwater by the Coagulation–magnetic Separation Method

An eco-environmental assessment of harmful algal bloom mitigation using modified clay